User manual SIEMENS LC754GA20B

[. . . ] 550 2 Instructions for use: Operating modes Exhaust-air mode: The extractor-hood fan extracts the kitchen vapours and conveys them through the grease filter into the atmosphere. The grease filter absorbs the solid particles in the kitchen vapours. D When the extractor hood is operated in exhaust-air mode simultaneously with a different burner which also makes use of the same chimney (such as gas, oil or coal-fired heaters, continuous-flow heaters, hot-water boilers) care must be taken to ensure that there is an adequate supply of fresh air which will be needed by the burner for combustion. Safe operation is possible provided that the underpressure in the room where the burner is installed does not exceed 4 Pa (0. 04 mbar). [. . . ] Insert the clean filters back into the hood. 7 Filters and maintenance Activated carbon filter: For neutralizing odours in recirculating mode. Caution: As the filter becomes more and more saturated with grease, there is an increased risk of fire and the function of the extractor hood may be impaired. Important: Change the activated carbon filter promptly to prevent the risk of fire from the accumulation of heat when deep-fat frying or roasting. Installation and removal: Warning: The halogen bulbs must be switched off and cool. Remove the metal-mesh filters (see "Removing and inserting the metalmesh grease filters"). Insert the metal grease filters (see "Removing and inserting the metal grease filters"). Replacing the activated carbon filter: During normal operation (1 to 2 hours per day) the activated carbon filters should be replaced approximately 2 x year. A replacement filter can be obtained from any authorized dealer (see optional accessories). By doing so you will obtain maximum performance from your extractor hood. Disposing of the old activated carbon filter: There are no pollutants in the activated carbon filters. They can therefore be disposed of as part of your normal domestic refuse. 8 Cleaning and care Isolate the extractor hood by pulling out the mains plug or switching off the fuse. Do not clean the extractor hood with abrasive sponges or with cleaning agents which contain sand, soda, acid or chlorine! Clean the extractor hood with a hot soap solution or a mild window cleaner. When cleaning the grease filters, remove grease deposits from accessible parts of the housing. This prevents the risk of fire and ensures that the extractor hood continues operating at maximum efficiency. Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. Clean the surface in the same direction as it has been ground and polished. Observe the warranty regulations in the enclosed service booklet. 9 Replacing the light bulbs Bulbs: 1. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. Even for some time after the bulbs have been switched off there is still a risk of burns. [. . . ] Ensure that the wall is capable of providing a firm hold for mounting screws and plugs. Weight in kg: Exhaust air 60 cm 70 cm 90 cm 16, 5 17, 2 18, 7 Recirculating air 18, 0 18, 7 20, 2 Electrical connection If you fit your own plug, the colours of these wires may not correspond with the identifying marks on the plug terminals. Connect the green and yellow (Earth) wire to the terminal in the plug marked `E' or with the symbol ( ), or coloured green or green and yellow. Connect the blue (Neutral) wire to the terminal in the plug marked `N' or coloured black. [. . . ]