User manual SIEMENS MOTION 101 BTE

[. . . ] Turn your hearing instrument off when not in use to preserve the battery. Don't use your hearing instruments (and remote control) in areas where there is a danger of explosions. 10 General notes on safety 5 CAUTION Risk of injury caused by incorrect use of LifeTip. Make sure that the LifeTip is completely attached to the LifeTip adapter. Put the LifeTube with the LifeTip carefully and not too deep into the ear. [. . . ] Return them to your Hearing Care Professional for environmentally correct disposal. 14 Handling of standard and rechargeable batteries 6 Battery compartment lock Your hearing instruments are equipped with a battery compartment lock. This prevents the unintentional removal of the batteries from their compartment. Lock Open the battery compartment to the first stop. Ask your Hearing Care Professional if you need assistance. 15 7 Inserting and removing your hearing instrument Inserting your hearing instrument Turn your hearing instrument off. Hold the earmold / LifeTip between your thumb and index finger and insert it carefully into the ear canal. You may find it helpful to pull your ear slightly upward or to the back. If the typeplate of your hearing instrument is in red, the hearing instrument is intended for the right ear. If the typeplate is in blue, the hearing instrument is for the left ear. Removing your hearing instrument Hold the earmold / LifeTube between your thumb and index finger and carefully pull it out. You may find it helpful to lightly push your ear from the back. 16 Turning your hearing instrument on and off 8 Turn on: Fully close the battery compartment to turn the hearing instrument on. Turn off: Press the battery compartment downward to the first stop to turn the hearing instrument off. You can also use the remote control to turn the hearing instrument on and off. Power-on delay Your hearing instruments are equipped with a , , poweron-delay" feature which can be activated by your Hearing Care Professional. This allows you to turn the hearing instrument on with an automatic delay, so that you may insert the hearing instrument into your ear without experiencing unpleasant feedback (whistling). The delay can be programmed by your Hearing Care Professional to be 6, 12 or 18 seconds. In this case, use the AutoPhone magnet, enclosed in your hearing instrument package, and attach it to the telephone receiver to activate the AutoPhone function. See the AutoPhone magnet user guide for instructions on how to position the magnet. Use only the magnet that is delivered with the hearing instrument. Manual telephone program Select the telephone program manually by using the program button. Your Hearing Care Professional will program your hearing instrument to fit your individual requirements. 22 Telephoning 12 CAUTION Magnets may interfere with the operation of life supporting systems (e. g. The safe distance between pacemaker and magnet should be at least 10 cm (4 inches). NOTICE Magnets pose risks to electronics and magnetic storage mediums when placed in close proximity. Do not to set magnets near computers, color monitors, television sets, floppy discs, video/audio tapes and other electronic equipment. When operating the hearing instrument in T-coil mode, the wireless function may cause a pulsing noise. In this case use the remote control with a distance greater than 10 cm (4 inches). 23 13 e2e wireless 2. 0 Your hearing instruments are equipped with e2e (ear-toear) wireless 2. 0 technology. Advantages of the wireless functionality: Automatically adjusts both hearing instruments simultaneously to different listening situations. [. . . ] Wait 18 seconds and check again. If you still encounter problems after trying these suggestions, consult your Hearing Care Professional. 30 Technical information 17 Operating frequencies: Fc=3. 28 MHz This Class B digital apparatus complies with Canadian ICES-003. Changes or modifications not expressly approved by Siemens Audiologische Technik GmbH could void the users authority to operate the equipment. Siemens Motion 700, Motion 500 FCC ID: SGI-WL002BTE IC: 267AB-WL002 N14203 This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 31 17 Technical information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ]