User manual SIEMENS S1WTF3800A

[. . . ] Instruction Manual and Installation Instructions en SIWAMAT XS 432 electronic Table of Contents Operating Instructions Safety Instructions . 3 5 6 7 8 11 12 13 14 18 20 21 22 Installation Instructions 2 Please read this instruction manual and all other infor mation accompanying the washing machine before operating the appliance. Please retain all documents for future reference or for a subsequent appliance owner. Safety Instructions General Your washing machine is intended: - For domestic use only. - For operation using cold tap water and conventional laundry detergents and additives that are suitable for use in washing machines. [. . . ] q Remove any loose debris / fluff from inside the pump and clean the pump. Clean any residual lye or fluff from the thread of the pump cap and pump housing. To avoid unused detergent from flowing into the drain during the next wash cycle: q Pour 1 litre / 1 ¾ pt of water into chamber II. q Select the b Drain" programme. 16 Cleaning water inlet strainers This is necessary if very little or no water flows into the washing machine. First release the water pressure in the supply hose: q Turn off the water tap. q Turn the programme selector to any programme (except 4 Spin" and Q Drain"). q Press the 3 Start" button, and allow the pro gramme to run for approx. 40 seconds. Cleaning the strainer at the water tap q Disconnect the hose from the water tap. q Reconnect the hose. Cleaning the strainer on the washing machine q Disconnect the hose from the back of the washing machine. q Pull out the strainer and rinse under running water. If water is still discharged, check that the strainer is attached properly. q Turn off the water tap. 17 Troubleshooting Minor Faults d Risk of electric shock!Repairs must only be carried out by our Customer Service or an authorized technician. If repairs are needed, and assuming that you cannot eliminate the fault yourself with the aid the following table: q Turn the programme selector to H Off". If you wish to unload the laundry, proceed as in Cleaning the drain pump", Page 16. Close the loading door (a click should be heard). Plug is loose or not inserted. Water does enter the machine or detergent is hi dt ti not washed away. Foam coming out of the detergent dispenser. Cause 3 Start" button not pressed. A programme without Prewash was selected. Action Press the 3 Start" button. Select "K 60 °C Cottons + Linens with Prewash". This is not a fault. Fluff producing laundry was washed Clean the water drainage pipe and/or drain hose. Mix 1 tablespoon of fabric softener with ½ litre / 1 pt of water and pour into chamber II of the detergent dispenser. Reduce the amount of detergent next time. The programme takes longer than usual. This is not a fault. [. . . ] Do not connect the appliance to the mixer tap of an unpressurized hot water boiler. If in any doubt, have the water connection carried out by an authorized technician. Observe the water pressure in the supply network: - The water pressure should be between 1 and 10 bars (when the tap is turned on, at least 8 litres of water is discharged per minute). - A pressure reducing valve must be installed if the maximum water pressure is exceeded. Connect the water supply hose q To the back of the washing machine, and. . . q To the water tap. [. . . ]