User manual SIEMENS SE65A560GB

[. . . ] Instructions for Use en 5600 049 758 (8205) en Index 4 6 6 7 8 9 10 Detergents . Filling the special salt container Filling the rinse-aid container Unsuitable dishes . . en Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. The wooden frames (if fitted) are made of residual wood and are untreated. [. . . ] If the water is still "clean" at the end of the pre-rinse cycle, then the same water is used for the following wash cycle. If the water is dirty, it is pumped out of the dishwasher and replaced by fresh water. 4 litres when the dishes are only "slightly" dirty. Programme data The stated programme data are based on standard operating conditions. The values can vary considerably according to: different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage machine-related factors (e. g. Energy and water consumption is reduced by up to 1/4 when dishes are washed in the upper basket only. Water consumption values are based on a water hardness setting of 4. 16 en Switching the dishwasher ON Turn on the tap. Indicators light up according to the last programme that was selected. This same programme will run again if no other programme button 7 is pressed The numerical display 4 shows the expected duration of the programme. The programme starts automatically. Switching the dishwasher OFF Several minutes after the programme has ended: Open the door when the programme has ended. (Does not apply when Aqua-Stop unit has been fitted) Remove dishes, etc. when they have cooled down. End of programme The end of the programme is indicated by a buzzer. This function can be changed as follows:­ Hold down Function button C pressed and switch on main switch 1 , then let the buttons go. Function Button C flashes, and the digital display indicates the value which was set at the factory (semi-loud). Each depression of the button increases the set value by one, when is reached, the display (off). The set value is stored in the appliance. Interrupting the programme Open the door. If the hot water was switched ON or the appliance has already heated up and then the appliance door opened, leave the door ajar for several minutes and then close. In order to continue with the stored programme, set the main switch to ON again and close the door. 17 en Programming the timer You can delay the start of a programme in increments of one hour for up to 19 hours. Press the TIMER button as many times as necessary until the numerical display shows the required delay. To erase the time delay setting, keep pressing the TIMER button until appears in the numerical display. You can change your programme selection as often as you like during the intervening period before the dishwasher starts up. Intensive drying If the "Intensive drying" function is activated, the temperature of the final rinse is increased in all programmes and you will therefore receive an improved drying result. (Note the higher temperature may not be suitable for fragile utensils. ) Hold down the programme button A and switch on the main switch. Switch off the main switch 1 ; the setting is stored. Time-remaining indicator The time-remaining indicator is self-learning. [. . . ] Ensure that the fresh water connection is not kinked, crushed or twisted. When replacing the appliance, always connect a new water supply hose to the water supply. Ensure that the fresh water connection is not kinked, crushed or twisted. If you do use hot water, the temperature should not exceed 60 °C. Delivery Your dishwasher was checked at the factory to ensure that it was in perfect working order. [. . . ]