User manual SIEMENS SN56T591GB

[. . . ] 9000 404 737 (8811) en Instructions for use en Index 4 4 4 4 4 4 4 5 5 5 5 6 6 6 7 7 8 8 9 9 9 9 9 10 10 10 10 10 11 11 11 12 13 14 14 14 15 15 15 15 IntensiveZone . 15 15 15 15 15 15 16 16 16 16 17 17 17 17 17 18 18 18 19 19 20 20 20 20 21 21 22 23 23 23 24 24 24 24 25 25 25 25 26 26 26 Safety instructions . . en Safety instructions Delivery Check the packaging and dishwasher immediately for damage caused in transit. Please dispose of the packaging material in an environmentally friendly manner. [. . . ] Hold down programme button A and press START button 10 until on is indicated. The LED for button A flashes and the digital display displays the factory setting . Press programme button A until the factory set value is indicated on the digital display 3 . To change the setting, By pressing the C button, you can switch the onboard computer (additional programme information) off or on . Close the door. End of programme The programme has ended when the value is indicated on the numerical display 3 . Hold down programme button A and press START button 10 until on the digital display is indicated. The LED for button A flashes and the digital display displays the factory . setting Press programme button A until the factory set value is indicated on the digital display . 16 en To change the setting, press programme button C . Each time the button is pressed, the set value increases by one level; when the has been reached, the value of (off). Close the door. Switching off the appliance Short time after the end of the programme: Open the door. Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Changing the programme When the START button 10 has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. Hold down programme button A and press START button 10 until on is indicated. The LED for button A flashes and the digital display displays the factory . setting Press programme button A until the factory set value is indicated on the digital display 3 . If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. Close the door. 17 en Interior light * 20 Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. The interior light comes on when the door is opened irrespective of whether the ON/OFF switch 1 is switched on or off. Hold down programme button A and press START button 10 until is indicated on the digital display. The LED for button A flashes and the digital display displays the factory . [. . . ] The expected programme duration is indicated on the numerical display 3 . (This prevents residual water from running into the machine control and damaging the programme sequence). Removing the appliance Also observe the sequence of worksteps here. Pull out the appliance, carefully pulling the hose behind. Protection against frost If the appliance is in a room where there is a risk of frost (e. g. Turn off the tap, disconnect supply hose and drain water. 25 en Waste disposal Both the packaging of new appliances and the old appliances themselves contain valuable raw materials and recyclable materials. [. . . ]