User manual SIEMENS SN65M000EU

[. . . ] 9000 299 935 (8712-1) en Instructions for use en Index 4 4 4 4 4 4 4 5 5 5 5 6 6 7 7 7 8 8 8 9 9 9 9 9 9 10 10 10 10 11 12 12 14 14 14 15 15 15 15 15 15 Washing the dishes . 15 15 15 15 16 16 16 16 17 17 17 17 17 18 18 18 19 19 20 20 20 20 21 21 22 23 23 23 23 24 24 24 24 25 25 25 25 25 Safety instructions . . en Safety instructions Delivery Check the packaging and dishwasher immediately for damage caused in transit. Please dispose of the packaging material in an environmentally friendly manner. [. . . ] Close the door. Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. Press 6 + or ­ button until the displayed time corresponds with your requirements. To delete timer programming, press the 6 + or ­ button until is indicated on the digital display. You can change your programme selection at any time until the programme starts. Close the door. End of programme The programme has ended when the value is indicated on the numerical display 9 . Hold down programme button A and press START button 8 until on the digital display is indicated. The LED for button A flashes and the digital display displays the factory . setting Press programme button A until the factory set value is indicated on the digital display . Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display 9 . The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). 16 en To change the setting, press programme button C . Each time the button is pressed, the set value increases by one level; when the has been reached, the value of (off). Close the door. Switching off the appliance Short time after the end of the programme: Open the door. Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Changing the programme When the START button 8 has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. Hold down programme button A and press START button 8 until on is indicated. The LED for button A flashes and the digital display displays the factory . setting Press programme button A until the factory set value is indicated on the digital display 9 . If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. Close the door. 17 en Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Filters The filters 26 keep large foreign objects in the rinsing water away from the pump. The filter system consists of a coarse filter, a flat fine filter and a microfilter. [. . . ] Inlet rate: minimum 10 litres/minute Water temperature: cold water preferred; hot water max. 60 °C. 24 en Transportation Empty the dishwasher and secure loose parts. Drain the appliance according to the following steps: Turn on the tap. The expected programme duration is indicated on the numerical display 9 . [. . . ]