User manual SIEMENS TC35I

[. . . ] Siemens Cellular Engine Version: DocID: 00. 01 TC35i_ATC_V00. 01 TC35i AT Command Set PRELIMINARY Document Name: TC35i AT Command Set Siemens Cellular Engines 00. 01 January 10, 2003 TC35i_ATC_V00. 01 Ready for distribution to customers Version: Date: Doc Id: Status: General note Product is deemed accepted by Recipient and is provided without interface to Recipient´s products. The Product constitutes pre-release version and code and may be changed substantially before commercial release. The Product is provided on an "as is" basis only and may contain deficiencies or inadequacies. The Product is provided without warranty of any kind, express or implied. [. . . ] Therefore, it must be limited to 10 characters comprising digits and the desired dial string modifier(s). A limited number of locations with extended memory is available per phone book. These locations allow storing numbers with twice the standard length, which is 2*<nlength> digits for normal numbers or <nlength> digits for numbers that cannot be stored in BCD format. If all extended locations of the selected phone book are used up, then any attempt to write a number which requires extended memory will be denied with CME ERROR 260: INVALID DIAL STRING. TC35i_ATC_V00. 01 Page 116 of 257 10. 01. 2003 TC35i AT Command Set PRELIMINARY 4. 35 AT+CPIN Enter PIN Test command Response AT+CPIN=? Read command OK Response AT+CPIN? TA returns an alphanumeric string indicating whether or not a password is required. +CPIN: <code> OK If error is related to ME functionality: +CME ERROR: <err> Parameter <code> SIM PIN authentication READY SIM PIN SIM PUK SIM PIN2 PIN has already been entered. ME is waiting for SIM PUK1 if PIN1 was disabled after three failed attempts to enter PIN1. ME is waiting for PIN2, when the attempt to access PIN2 requiring features was acknowledged with +CME ERROR:17 (e. g. This is only applicable if the AT+CPIN read command also prompts for SIM PIN2. Necessary if preceding command was acknowledged with error +CME ERROR:18 and only if the AT+CPIN read command also prompts for SIM PUK2. Normally, the AT+CPIN2 command is intended for SIM PUK2. SIM PUK2 Phone security locks: PH-SIM PIN ME is waiting for phone-to-SIM card password if "PS" lock is active and user inserts other SIM card than the one used for the lock. ME is waiting for Master Phone Code, if the above "PS" lock password was incorrectly entered three times. PH-SIM PUK Factory set SIM locks PH-FSIM PIN ME is waiting for phone-to-very-first-SIM card. When powered up the first time, ME locks itself to the first SIM card put into the card holder. As a result, operation of the mobile is restricted to this one SIM card (unless the PH-FSIM PUK is used as described below). 10. 01. 2003 TC35i_ATC_V00. 01 Page 117 of 257 TC35i AT Command Set PRELIMINARY PH-FSIM PUK ME is waiting for phone-to-very-first-SIM card unblocking password to be given. Necessary when "PF" lock is active and other than first SIM card is inserted. ME is waiting for network personalisation password ME is waiting for network personalisation unblocking password ME is waiting for network subset personalisation password ME is waiting for network subset unblocking password ME is waiting for service provider personalisation password ME is waiting for service provider personalisation unblocking password ME is waiting for corporate personalisation password ME is waiting for corprorate personalisation unblocking password PH-NET PIN PH-NET PUK PH-NS PIN PH-NS PUK PH-SP PIN PH-SP PUK PH-C PIN PH-C PUK See Chapters 4. 21 and 7. 15 for information on lock types. Write command Response AT+CPIN=<pin> [, <new pin>] The write command lets the ME store the entered password. This may be for example the SIM PIN1 to register to the GSM network, or the SIM PUK1 to replace a disabled PIN with a new one, or the PH-SIM PIN if the client has taken precautions for preventing damage in the event of loss or theft etc. OK If error is related to ME functionality: +CME ERROR: <err> If no PIN request is pending (for example if PIN authentication has been done and the same PIN is entered again) ME responds +CME ERROR: operation not allowed. No action is required from your part. Parameter <pin> <new pin> password (string type), for example SIM PIN or, if requested, one of the unblocking keys, such as SIM-PUK or PH-SIM PUK. If the ME is waiting for an unblocking key, use <pin> to enter the unblocking key, followed by <newpin> to specify the password. See Chapter 4. 35. 1 for more information about when you may need to enter an unblocking key. Reference Note GSM 07. 07 · Caution: After entering a password with AT+CPIN all other commands that need access to data on the SIM card may be blocked for up to 20 seconds. The response in these cases will be "+CME Error: 14" (SIM busy). · Successful PIN authentication only confirms that the entered PIN was recognized and correct. [. . . ] (Unblock SIM card after 3 failed attempts to enter PIN1) See also Chapters 4. 21, 4. 35, 4. 35. 1, Unlock PIN2 (after 3 failed attempts to 4. 36. enter PIN2) Unlock "PS" lock with Master Phone Code Registration of net password (change call barring password) Call barring (see also Chapter 8. 4. 1) (choice of *, #, *#)33*Pw*BS# (choice of *, #, *#)331*Pw*BS# (choice of *, #, *#)332*Pw*BS# (choice of *, #, *#)35*Pw*BS# (choice of *, #, *#)351*Pw*BS# #330*Pw*BS# #333*Pw*BS# #353*Pw*BS# Act/deact/int BAOC Act/deact/int BAOIC Act/deact/int BAOIC exc. home Act/deact/int. All Inc. Barring Services ^SCLCK: <fac>, <status>, <class> [, . . . ] Refer to Chapter 4. 21 for a description of parameters and Chapter 8. 4. 1 for differences regarding the responses ^SCLCK and +CLCK. TC35i_ATC_V00. 01 Page 252 of 257 10. 01. 2003 TC35i AT Command Set PRELIMINARY *# code Call Hold / Multiparty C[C] in call USSD messages [C]. . . [C]# (varies with the serving network) C[C] (excluded 1[C]) (varies with the serving network) Send USSD message Send USSD message +CME ERROR: <err> / OK OK (see Chapter 4. 48, p. 138) +CME ERROR: <err> / Call hold and multiparty +CME ERROR: <err> / OK (see Chapter 4. 16, p. [. . . ]