User manual SIEMENS WXS862OE

[. . . ] Instruction Manual and Installation Instructions en SIWAMAT XS 1062 XS 862 Table of Contents Operating Instructions Safety Instructions . 3 5 6 7 8 12 13 14 15 20 23 24 25 Installation Instructions Appendix Additional guarantee . . 34 2 Please read this instruction manual and all other infor mation accompanying the washing machine before operating the appliance. Please retain all documents for future reference or for a subsequent appliance owner. Safety Instructions General Your washing machine is intended: - For domestic use only. [. . . ] q Remove the service flap. 90 °C max. q Pull down the closing cap and allow the washing lye to flow into a suitable container. 17 q Push up the closing cap (1st) and place the drain hose back in its holder (2nd). q Carefully remove the pump cap. Clean any residual lye or fluff from the thread of the pump cap and pump housing. To prevent unused detergent from flowing into the drain during the next wash cycle: q 1 Pour 1 litre / 1 ¾ pt of water into chamber II. q Select the b Abpumpen" programme. 18 Cleaning water inlet strainers This is necessary if very little or no water flows into the washing machine. First release the water pressure in the supply hose: q Turn off the water tap. q Turn the programme selector to any programme (except 4 Schleudern" and Q Abpumpen"). q Press the 3" button, and allow the programme to run for approx. 40 seconds. Cleaning the strainer at the water tap q Disconnect the hose from the water tap. q Reconnect the hose. Cleaning the strainer on the washing machine q Disconnect the hose from the back of the washing machine. q Pull out the strainer and rinse under running water. If water is still discharged, check that the strainer is attached properly. q Turn off the water tap. 19 Troubleshooting Minor Faults d Risk of electric shock!Repairs must only be carried out by our Customer Service or an authorized technician. If repairs are needed, and assuming that you cannot eliminate the fault yourself with the aid the following table: q Turn the programme selector to Aus". If you wish to unload the laundry, proceed as in Cleaning the drain pump", Page 17. Plug is loose or not inserted. 20 Fault Programme does not start. Water does enter the machine or d t hi detergent iis t not washed away. Water cannot be seen in drum. Cause Loading door not closed. Action Check whether laundry is trapped in door. Close the loading door (a click should be heard). 3" button not pressed. A programme without Prewash was selected. Press the 3" button. Select "K + Koch/Bunt" (60 °C Cottons + Linens with Prewash). This is not a fault. The water lies below the visible part of the drum. Loose debris is blocking the pump. The Fluff producing laundry was washed Clean the water drainage pipe L" control light flashes. Mix 1 tablespoon of fabric softener with ½ litre / 1 pt of water and pour into chamber II of the detergent dispenser. [. . . ] q After connection: Turn on the water tap completely and check that the connection points are water tight. min. 10 mm 30 Water drainage Caution Do not bend or pull the water drainage hose. Height difference between the placement area and drainage point: Minimum 60 cm, maximum 100 cm. Drainage into a siphon: q Secure the connection point with a hose band clip of 24 40 mm dia. [. . . ]