User manual SIMA RCW-103

[. . . ] Press the MODE button three times and the time zone will be displayed. Press and hold the SET button for three seconds or until the offset hours digits begin to flash. Press the RECEIVE button to increase or press the LIGHT button to decrease the hour-offset. For standard time: (Eastern = -5) (Central = -6) (Mountain = -7) (Pacific = -8) 5. [. . . ] Pressing the LIGHT button while in manual Press the RECEIVE button or the setup decreases the digits displayed on the LIGHT button to reset the seconds to LCD. Press the SET button one more time decrease the numbers at a faster rate. Day of Week SET Pressing and holding the SET button for three seconds enters the manual setup mode. Different settings can be accessed by pressing the SET button repeatedly . EL (RCW-101 only) Pressing the EL button will activate the RCW backlight. SETTING ALARM 1 & ALARM 2 The RCW has two alarms that can be activated, AL1 and AL2. If no button is pushed, it will automatically shut off after two minutes. 2) Press and hold the SET button for three seconds. The hour section of the clock will begin blinking. 3) Press the RECEIVE button to increase the hour or the LIGHT button to decrease the hour. 5) Press the RECEIVE button to increase the minute or the LIGHT button to decrease the minute. The icon for ON/OFF is located above the second portion of the clock (on=ON, oF=OFF). 8) The RCW will return to normal operation in approximately 15 seconds. 4 3 SET 5 6 7 RECEIVE 2 1 MODE 8 LIGHT 9 SIGNAL SEARCH AUTOMATIC SEARCH The RCW is designed to receive the NIST signal automatically every night at 3:00AM. The RCW will synchronize the time and date with the NIST broadcast signal from Fort Collins, CO. Note: You must set the watch manually the first time for it to auto synch during the night. RECEPTION STATUS If the NIST broadcast is successfully received, the tower icon in the upper left corner of the LCD will remain "on" all day. If the reception was not successful, the tower icon will be "off" which means that the signal was not received in the past 24 hours. The RCW will automatically search at 3:00AM everyday to update its time. (Note: If the tower icon is not "on" in the upper left corner, follow the instructions in the MANUAL SIGNAL SEARCH section). MANUAL SIGNAL SEARCH When the tower icon is not present in the upper left hand corner of the LCD the NIST signal has not been received in the previous 24 hours. The RCW searches for the NIST transmission at 3:00AM every night; which is the best time to receive the signal. In the event that your RCW does not have the tower icon displayed the RECEIVE button can be pressed to attempt to receive the signal. Press and hold the RECEIVE button for ten seconds to activate the signal receiver. [. . . ] - Keep your RCW away from the strong electromagnetic fields and static electricity. Your RCW is a delicate instrument and requires special tools for changing the battery; therefore, Sima strongly recommends that qualified personnel only change the battery. Automatic reception of the NIST signal will activate once the battery is replaced. LIMITED WARRANTY Sima Products Corp. ("Sima") warrants that if the accompanying product proves to be defective to the original purchaser in material or workmanship within 90 days from the original retail purchase, Sima will, at Sima's option, either repair or replace same without charge (but no cash refund will be made). [. . . ]