User manual SMEG FS64MF/A

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SMEG FS64MF/A. We hope that this SMEG FS64MF/A user guide will be useful to you.


SMEG FS64MF/A : Download the complete user guide (2732 Ko)

Manual abstract: user guide SMEG FS64MF/A

Detailed instructions for use are in the User's Guide.

[. . . ] WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THERE IN BEFORE USING THE COOKER. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USES AND CONFORMS TO CURRENT REGULATIONS IN FORCE. THE APPLIANCE HAS BEEN BUILT TO CARRY OUT THE FOLLOWING FUNCTIONS: COOKING AND HEATING-UP OF FOOD. [. . . ] After switching off the alarm, the display will once again show the right time together with the symbol , indicating that the oven has returned to manual operation mode. 18 Instructions for the user 6. 5 Minute Counter The programmer can also be used as a simple minute counter. By pressing key , the display shows ; keep the key pressed and at the same time press keys or . On releasing the key , programmed counting will begin and the display will show the current time and the symbol . Use as a minute counter does not interrupt functioning of the oven at the end of the programmed time. 6. 6 Adjusting alarm volume The acoustic alarm has three different settings. These can be operated, while the alarm is sounding, by pressing key . 6. 7 Switching off the alarm The alarm switches off automatically after seven minutes. To switch off the appliance, rotate all the knobs to position 0. 6. 8 Cancellation of set data Once the programme has been set, keep the key of the function to be cancelled pressed, while at the same time is reached by means of variation keys or . Time cancellation will be considered as end-ofcooking time by the programmer. 6. 9 Changing the set data The cooking data entered can be changed at any time by keeping the function key pressed and at the same time adjusting the keys or . 19 Instructions for the user 7. DIGITAL TIMER (ONL ON EQUIPPED MODELS) Y LIST OF FUNCTIONS MINUTE-COUNTER KEY DECREASE TIME KEY INCREASE TIME KEY 7. 1 Setting the time When the oven is used for the first time, or after a power blackout, the display flashes on and off at regular intervals showing . key and keep it pressed until the required 7. 2 Setting the timer To set the timer, press the number of minutes is shown. When the key is released, after 5 seconds the countdown will start; once this finishes, an acoustic device will sound. During the countdown the display will show the symbol; pressing the key displays the current time for 5 seconds. 7. 3 Deactivating the acoustic device key. The acoustic device stops sounding automatically after seven minutes. To prevent any steam in the oven creating problems, open the door in two stages: half open (5 cm approx. ) for 4-5 seconds and then fully open. To access food, always leave the door open as short a time as possible to prevent the temperature in the oven from falling and ruining the food. 9. 2 Cooling system The oven is equipped with a cooling system which automatically comes on upon a few minutes after the oven has been turned on. Fans cause a steady outflow of air from above the door which may continue for a brief period of time even after the oven has been turned off. 23 Instructions for the user 9. 3 Use of the gas oven 9. 3. 1 Electronic spark lighting Open the oven door completely, press the thermostat knob and turn it clockwise to max. Once the oven is lit, hold the knob down for a few seconds to allow the thermocouple to heat up. This device should not be enabled for more than 15 seconds; if after this time the burner has not come on, stop, fully open the oven door and try again after one minute. 9. 3. 2 Manual lighting Open the oven door completely and turn the thermostat knob. Place a lit match to the mouth of the flame pipe A in the centre of the oven floor and press the thermostat knob. Once the oven is lit, hold the knob down for a few seconds to allow the thermocouple to heat up and check that the oven is lit through the inspection hole B. Choose the cooking temperature by turning the knob clockwise to the desired temperature, between 50° and 275°C. If the burner is accidentally switched off, turn the knob to the off position ( ) and wait for one minute before lighting again. 9. 4 Use of the electric grill 9. 4. 1 Using the grill in cookers with electric oven For short cooking procedures, such as the final crisping of meat which is already cooked, select the static grill function and turn the thermostat knob to the maximum temperature. The fan grill function (certain models only) allows actual cooking procedures to be carried out, thanks to the fan function which ensures that the heat penetrates into the food. [. . . ] Wash them in hot water with non-abrasive detergent, taking care to remove any incrustations, and wait until they are perfectly dry. Replace the flame-spreader crowns, checking that they are positioned in their housing with their respective caps, taking care that flame-spreader holes A correspond to the spark plugs and the thermocouples. 32 Instructions for the user 12. 2. 3 The spark plugs and thermocouples To function properly the spark plugs and thermocouples must always be clean (on the models which are equipped with them). Any dry residues can be removed with a toothpick or a needle. 12. 2. 4 The burners The burners can be left to soak in hot water and detergent. 12. 3 Cleaning of oven For best oven upkeep clean regularly after having allowed to cool. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE SMEG FS64MF/A




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SMEG FS64MF/A will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.