User manual SOLAC AA3400 ECOGENIC

[. . . ] Do not leave the cord hanging over the edge of a table or worktop, to prevent children from pulling it and causing the appliance to fall. En d • • • • • • • • • • • • • • Never immerse the appliance in water or any other liquid, and do not put it in the dishwasher. Never use the robot vacuum cleaner without the dustbin or the protective filter adequately fitted. Keep hair, clothes, fingers and any other body areas away from the vacuum module, rollers and wheels. [. . . ] 20 USING THE APPLIANCE , If you wish, you can control its movements or functions using the remote control buttons (please refer to the “REMOTE CONTROL” section), or using the buttons of the control panel on the robot vacuum's body. This function is particularly recommended for people suffering from allergies and for homes with pets, as it sterilises the floor against viruses and bacteria. 9 If you do not want a programmed weekly clean, turn off the appliance after cleaning. To do so, set the operating switch (20) to the OFF position or press the ON/OFF button on the remote control. VIRTUAL BARRIER MAIN COMPONENTS (B) 1B ON switch & Length of virtual barrier Off Short range = 4 m Medium range = 6 m Long range = 8 m 2B 3B 4B 5B 6B LED ON light Proximity sensor head Virtual barrier sensor head Battery compartment cover Battery cover clip en OPERATION , Use the virtual barrier to define the desired cleaning area, preventing the robot from ) ) ) , 1 2 3 4 , , , 5 6 entering unnecessary or unwanted areas. Use this to prevent the robot entering areas with cables or a particular room. Place the virtual barrier at the same level on the surface where you are going to use the robot vacuum. Place the virtual barrier and the charging station at a distance of more than 3 m apart, to prevent interferences. Do not place the charging station within range of the virtual barrier’s signal. The proximity sensor head (3B) prevents impact between the robot vacuum and the virtual barrier, preventing it from coming within a distance of less than 0. Position the virtual barrier so that it blocks the area you do not want the robot vacuum to enter. Remove any objects that may be in front of the virtual barrier, to prevent its inadequate operation. The LED ON light (2B) will flash every 8 seconds until the battery runs out. Check that the robot vacuum cannot cross the boundary created by the virtual barrier. Set switch (B) to the OFF position , when the virtual barrier is not required. Some differences may occur in the direction of the virtual barrier’s infrared signal and the robot's reception range, due to the movement of the robot during while in use. This difference may vary depending on the work environment and the charging level of the robot and the virtual barrier. VIRTUAL BARRIER 21 REMOTE CONTROL COMPONENTS (C) 1 2 3 4 Robot vacuum ON/OFF Direction buttons Confirmation button Control keys Start/Sunday Provisional stop/Monday Time setting/Tuesday Charge/Wednesday Timer/Thursday Fast clean/Friday Clean after charging/Saturday Slow clean/every day 5 Display (fig. 4) a Transmitting signal” icon b Programmed days of the week c Programmed days of the week d Time e Error icon f Function icon TIMER Synchronisation of the Remote Control and the Robot Vacuum (fig. 5) , Synchronise the remote control and the robot vacuum before first use and following maintenance operations. To do so: 1 Check that the batteries of the robot vacuum and the remote control are sufficiently charged. Return the operating switch (20) to the ON position, without releasing the button. [. . . ] , Keep the infrareds clean so that the robot vacuum can operate correctly. ) Clean the appliance after using it for the first time, immediately after each use and after a long period without use. You will thus ensure the correct operation of the appliance and prolong its useful life. Check that the positive and negative electrodes are in the proper positions. [. . . ]