User manual SOLAC AB2650

[. . . ] If you observe any anomaly in the electrical cord or any other part of the appliance, do not use it and contact an authorised after-sales service. â· Do not use parts or accessories that are not supplied or recommended by SOLAC. â· Before plugging the appliance into the mains, check that the voltage indicated corresponds to the voltage in your home. [. . . ] 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 Main body Power cord Bag compartment Compartment opening latch Bag compartment opening Flexible hose fitting Flexible hose Release tabs for the flexible hose Handle Mechanical power regulator Telescopic metal tube Adjustment button Floor and carpet brush Brush button Tip for vacuuming grooves and corners On/Off and electronic power regulation control Dust-bag full indicator Carrying handle and cord collector button Paper dust-bag Plastic support for the bag Bag holder tab Bag carton notch Motor protection filter Rubber seal Air outlet filter cover Air outlet filter Lid opening button This appliance has been exclusively designed to vacuum clean floors, carpets , furniture and fabrics. Unplug the plug from the mains before placing or removing Accessories or opening the cover of the bag compartment. 2 Fit the flexible hose (7), placing the fitting (6) in the bag compartment opening (5), until you hear a click. To remove the hose, press the detach latches (8), turn and pull on the fitting. 3 Prepare the accessories that correspond to the surface you desire to clean. The attachments can be placed directly on the flexible hose (7) or, for out-of-reach places, the telescopic metallic tube (11) can be used. â· The suction brush (13) on these models can be used for all types of floors, carpets and rugs. We recommend cleaning hard floors, wood and parquet with the fibre brush enabled, and cleaning carpets and rugs with the fibre brush retracted. â· This model is supplied with a vacuum nozzle for narrow places, grooves and corners (15) that can be placed directly on the flexible hose (7) or the telescopic metal tube (11). â· The length of the telescopic tube (11) can be changed by moving the adjustment button (12) while moving both parts of the telescopic tube. If necessary, the cord can be pulled out to the red mark, but not any further. 5 Place the operating and regulating knob (16) at the MIN position and plug into the mains. 6 Switch the vacuum cleaner on by pressing the control knob (16) and regulate the motor power by turning the knob (do not press the kob, because this will switch off the vacuum cleaner). Notice that the knob (16) has both the on/off function (by pressing) and the motor power regulating function (by turning). 7 Suction power can also be adjusted by opening or closing the mechanical power regulator on the handle (10). 8 When finished, switch the appliance off by pressing the ON/OFF button (16). unplug it and press the button (18) on the handle to wind up the cord. Hold the cord plug in your hand to prevent it from banging against the vacuum cleaner housing. [. . . ] This will rule out that poor placing of the filter or of the dust-bag, or tears or leaks in the bag obstruct the appliance and reduce suction capacity. 1 Remove the cover of the outlet filter by pressing on the opening button (27), (fig. 3 Insert the new filter in the cover and place the cover with the filter in its place (fig. [. . . ]