User manual SOLAC AE2540

[. . . ] Keep hair, clothes, fingers or any other body part away from the air intakes and outlets. Do not use the appliance in confined spaces where explosive or toxic vapours can build up. Never insert the charger in water or any other liquid or place in a dishwasher. [. . . ] 2 Select the necessary accessory, depending on the purpose for which you are going to use the broom (fig. Insert the multipurpose brush (19) in the suction outlet and push inwards until you hear a click. To remove it, press lightly on the multipurpose brush release button (20) and pull outwards. 3 Adapt the broom size as necessary by adjusting the length of the telescopic pole (15) (fig. Slide the handle release button (5) in the direction shown in the figure and pull the handle (4) in the opposite direction to extend the pole. Release the release button (5) when you have reached the desired length in order to lock the telescopic pole. To shrink the telescopic pole, slide the handle release button (5) in the direction shown in the figure and push the handle inside the main broom body. If during operation you hear a high-pitched whistle, different to the normal noise that the appliance makes, switch off and unplug the appliance. 5 Once you have finished vacuuming, switch off the appliance by placing the switch (3) in the OFF position. N Before you clean or perform any maintenance work on the appliance, ensure that it is For optimum performance, you are advised to clean the collector and filters after each use. When you need to empty the dust collector, ensure that the appliance is disconnected and proceed as follows: 1 Push the collector release button (11) downwards and remove the collector. 2 Remove the filter unit (12-13-14) by holding the collector firmly and pulling the filter tongue outwards. Shake the filter unit over a bin or use a brush to clean it thoroughly. 3 Once you have removed the collector filters, empty the collector into a bin. 4 To clean the filters thoroughly, remove the case (12) by rotating anticlockwise and remove the filter (13) from the bracket by pulling it outwards (fig. 5 If it is very dirty, wash the dust collector and the filters underneath running water using a gentle detergent (fig. Important: make sure they are completely dry before you replace them in the collector. 7 Place the filter unit (12-13-14) in the dust collector, matching the filter air inlet hole up to the collector air inlet hole and push the filter inwards until it is held firmly in place inside the collector. [. . . ] The warranty shall be rendered null and void by any of the following: · If the corresponding bill of sale, receipt or delivery note is not provided or if the information on these documents is altered. If the appliance has been used for professional cleaning and not for domestic cleaning only. If the appliance has been taken apart or altered by anyone outside the technical service centres authorised by SOLAC. [. . . ]