User manual SOLAC AS3258

[. . . ] This appliance is not to be used by persons (or children) whose physical, sensorial or mental capacities are impaired, or who have no experience or knowledge, unless supervised or instructed in the use of the appliance by a person responsible for their safety. In the event of any anomaly in the cord or any other part of the appliance, do not use it and take it to an authorised service centre. Do not use any parts or accessories not supplied or recommended by SOLAC. Before plugging the appliance into the mains, check that the indicated voltage is the same as in your home. [. . . ] Completely remove all the elements used for transportation and packaging. Unplug the appliance from the mains before adding or removing any accessories or performing any maintenance tasks. See the following section (Cleaning and Conservation) 2 Insert the flexible hose (13) into the connection (12) until it clicks into place When you want to remove the hose, press the release tabs (11) at the same time. It can be used on all types of floors, as it is retractile and can adapt to the surface to be cleaned. to change the cleaning position of the brush , press the brush button (25) with your foot. We recommend cleaning hard floors, wood and parquet with the fibre brush extended, and cleaning carpets and rugs with the fibre brush retracted. The length of the telescopic tube can be adjusted (20) by sliding the adjustment button (21) while moving both parts of the telescopic tube. 7 Switch the vacuum cleaner on by pressing the foot button (2) and adjust the suction power by opening or closing the regulator on the handle (19). (Opening the valve reduces the power and closing it increases the power). ) If, while using the appliance, you hear a sharp whistle unlike the usual sound, turn it off and unplug it. , This appliance has a position known as "horizontal parking", which can be used for pausing from time to time during cleaning. This position is achieved by holding the telescopic tube by the hook in the groove (4) of the appliance body (fig. , All these accessories can be stored in the accessory holder (22) housed in the telescopic metal tube (fig. 8 Once you have finished, switch the appliance off by pressing the button (2). Hold the cord plug in your hand to prevent it from banging against the vacuum cleaner housing. If for any reason the vacuum cleaner should overheat, the thermostat will automatically shut off the appliance. If this should happen: 1 Press the on/off switch (2) and unplug the appliance from the mains. ) If the automatic shut-off was due to the motor overheating, wait for about one hour for the appliance to cool before turning it on again. [. . . ] To do so: 1 Release and remove the grille from the air outlet filter (6) as shown in figure 6. 3 Gently tap the outlet filter against the side of the waste bin to remove any excess dirt and dust. ) Clean the appliance before using it for the first time, immediately after each use and After not using it for a long period of time. You will thus ensure the correct operation of the appliance and prolong its useful life. [. . . ]