User manual SOLAC BA5510

[. . . ] If it is, take it to an authorized distributor for inspection and repair, as special tools are required to replace it. â· Always unplug it while not in use and before fitting or detaching the different parts of the appliance. It may be run continuously for 10 minutes in positions 1 to 5 (mixer and blender rods). [. . . ] â· The TURBO button (6) enables you to use the mixer at the highest speed possible for a few seconds. For this purpose, with the speed selector (7) at the desired position, keep the button (6) pressed for as long as you want it to operate (maximum 30 seconds) (fig. To remove the rods (8 or 9) from the main body (1), press the release button (5) (fig. Do not press the button (5) while the appliance is working, as the rods would drop out. â· When the process is concluded, unplug the appliance from the mains. â· The turbo cannot be switched on in position 0 for safety reasons. For doughs that need a long mixing time, use the support (12) and the bowl (13). In this way, you will save having to hold the appliance in your hand and you will achieve a uniform mix, as the bowl rotates automatically. â· Place the bowl with the rods (13) on the support base (12) (fig. To fit the main body (1) on the support (12): engage the slot at the back of the main body on the locking tab (15), then press down until the anchoring tab (14) engages in its seat (fig. IMPORTANT: The blender rod with the metal washer must be inserted in the wide hole. â· Move the main body forwards again until engaging the tab (16), so that the rods are in the bowl (fig. In this case, the appliance may be operated for a maximum of 10 minutes. Before attaching the blender arm (10) to the body of the appliance, make sure that it is switched off and unplugged. [. . . ] â· Wash the rods (8 or 9), the blender arm (10), the support (12) and the bowl (13) with soapy water. Should the appliance fall into water, do not try and pick it up, unplug it from the mains. Basiselement Aankoppeling voor mix-/pureerstaaf Afdekking van de koppeling voor mix-/pureerstaaf Houder voor garden en kneedhaken Toets voor het verwijderen van de garden en kneedhaken Turboschakelaar Snelheidskeuzeschakelaar Kneedhaken Garden Mix-/pureerstaaf Mixbeker met deksel Tafelstandaard Gedwongen aangedreven roterende kom Bevestigingsrand Veiligheidsrand Aanzetsel voor het optillen van het basiselement Steek de garde met de ring in de brede opening en de garde zonder ring in de smalle opening, anders kunnen zij niet aangrijpen. [. . . ]