User manual SOLAC CH6350

[. . . ] Move the selector control (6) back to the OFF position (o) and fill the tank with the required amount of water. WARNING • This appliance is intended to be used in household applications such as: staff kitchen areas in shops; offices and other working environments; farm houses; by clients in hotels, motels and other residential type environments; bed and breakfast type environments. Using it for any purpose other than the one indicated could be dangerous. € This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. [. . . ] Never immerse the main body in water or any other liquid, or put it in the dishwasher. The appliance should not come into contact with water during cleaning. USING THE STEAMER you insert the steamer to the very bottom of the container, it could cause splattering, which could cause burns. ZTo foam the hot liquid, introduce only the tip of the steamer into the jug. 2 Using the jug (13), pour the required amount of water into the fill opening (2). I The amount of water required to heat a cup (200-250 cc) is approximately 40 cc. 5 Move the OFF/COFFEE/STEAM selector (6) into the STEAM position (fig. I The red indicator light (3) will come on, indicating that the coffee maker is in operation. 6 Insert the steam nozzle (4) into the jug or receptacle that contains the liquid to be heated. 7 To increase the steam flow rate, turn the selector control (6) to its fully open position. 8 Once the liquid has been heated to the desired temperature, allow some steam to flow out for a moment to clean the openings. The indicator light (3) will go out, indicating that the coffee maker is off. If q 1 MAIN COMPONENTS 1 Cover of the water fill opening 2 Water fill opening 3 ON-OFF indicator light 4 Steamer 5 Removable tray 6 OFF/COFFEE/STEAM selector control 7 Dispenser spoon 8 Filter with dose indicator for 2/4 cups 9 Filter holder 10 Filter holder flap 11 Coffee outlet hole 12 Jug lid 13 Measuring jug for up to 4 cups 14 Filter holder support 15 Power cord 2 USE ZThis appliance has been designed for coffee extraction and for PREPARACIÓN DE CAFÉ 1 Llene el depósito de agua, para ello: desenrosque la tapa (1) girándola en sentido contrario de las agujas del reloj. Coloque de heating milk and other liquids (water, broth, chocolate) using hot steam. ZBefore using the machine with coffee for the first time, we recommend you allow 4-8 cups of water to run through the filter holder. € Before cleaning the appliance, make sure it is unplugged from the ZClean the appliance before using it for the first time, immediately ZDo not use foreign objects (pens, screwdrivers, nails, awls, etc. ) in Cleaning the filter holder 1 Remove the dregs from the filter and rinse the filter and the filter holder. 1 Clean the body of the coffee maker and the rest of its plastic parts using a cloth slightly moistened with soapy water. 2 Using the jug (13), pour the required amount of water for two or four cups into the fill opening (2). 6 Use the dispenser spoon (7) to fill the filter (8) up to the mark corresponding to the desired cups of coffee (two or four), without pressing the coffee too much. [. . . ] Cleaning the steamer 1 If you use the steamer to heat milk, clean it as soon as possible afterwards for easier cleaning. 2 Every now and again, clean the steamer more thoroughly, as follows: Wait until the steamer cools and unscrew the cylindrical part of the same. Wipe the steamer spindle with a damp cloth and wash the cylindrical part with soap. Make sure that the small hole at the top of the steamer is clean before putting the part back on. [. . . ]