User manual SOLAC CO8500

[. . . ] This appliance is exclusively for household use and not for industrial use. It is dangerous to use it for any purpose other than the one indicated. Children must be supervised to ensure they do not play with the appliance. [. . . ] If the power cord is damaged, it should be replaced by the manufacturer or by your after-sales service shop or similar qualified personnel to prevent possible hazards. Remove all elements from the inside or outside of the appliance used for protection during transport or for sales promotions, such as paper or plastic bags, plastic sheets, cardboard and stickers. 1 Main body 2 Switch I (750 W) 3 Switch II (1250 W) 4 Fan switch 5 Temperature thermostat 6 Mains power cable 7 Plastic legs (2 units) 8 Wall brackets (4 units) 9 Screws for legs/lower wall bracket (4 units) 10 Nylon wall plugs (4 units) 11 Screws (4 units) For floor use: For wall use: 1 Fix the legs to the bottom of the appliance using the screws (9) provided (fig. Choose the place where the heater is to be installed carefully according to the instructions and in compliance with regulations. To avoid the new smell of the appliance when using it for the first time, switch it on and leave it operating for 2 hours at the highest temperature. The appliance must be installed so that the switches, thermostat and power cable cannot be touched directly or indirectly by a person in the bath or shower. Keep the front of the appliance at least 90 cm from furnishings, inflammable materials, curtains, carpets, armchairs, etc. The appliance must be connected to a power socket with a suitable ground connection. When you want to dispose of the appliance, NEVER throw it in the rubbish bin. Take it to the CLEAN POINT or waste collection centre closest to your home for processing. The appliance should never be covered with clothes, containers or any other objects, nor should it be placed under a wardrobe or anything else that could obstruct the hot air flow. 4 Fix the lower brackets (8) to the heater using the screws provided (9) (fig. 6 With the heater in place, mark on the wall the position of the hole to be drilled for fixing the lower bracket. 7 Drill the hole into the wall and insert the supplied wall plug (if necessary, remove the heater so you can work without obstruction, replacing it when you have finished). 8 Fix the lower bracket (8) to the wall using the plug and screws provided (fig. Z To mount the heater on a plastered brick wall, use the screws and wall plugs provided. [. . . ] Do not use abrasive products or those incompatible with epoxy paint: this may discolour the apparatus. Îndeprtai toate elementele care au fost folosite pentru protejarea aparatului pe durata transportului sau pentru promoii de vânzare, cum ar fi pungi de plastic sau de hârtie, foi de plastic, cartoane i etichete, care sunt prezente atât în interiorul aparatului cât i pe exteriorul acestuia. I Radiatorul cu aer are un termostat de siguran care se oprete automat în cazul unei supraînclziri accidentale (de exemplu, dac grilajele de admisie i evacuare a aerului se blocheaz). [. . . ]