User manual SOLAC CP7395

[. . . ] Ebony Complet works without cables, to obtain an optimum result with complete freedom of movement. Our aim is to offer you maximum functionality and convenience in a single appliance. We thank you for purchasing our product and hope you enjoy using your new Solac grooming kit. [. . . ] Place the personal grooming appliance (1) in the off position "0" and place it on its charging base (11). During the charging operation, the pilot light (3) lights up red, and changes to green when the appliance has finished charging. The first time you charge the personal grooming appliance (1), it will take approximately 24 hours. The appliance can only be charged when the switch is in the `0' position (Fig. 3) · When charging or recharging the appliance, the room temperature should not be below 15ºC or above 35ºC, as this may affect battery life. Seven hours' charging time when recharging the appliance will give about 75 minutes' operating time. If the appliance is not used for a month, recharge it fully before use. For optimum battery life, use the appliance until the battery is completely run down and then recharge it fully. This comb allows you to adapt the cutting length according to your needs. Level 10: 10 mm B) Shaving head (10): for comfortable shaving of facial areas, fixing the edge of the beard, goatee, etc. Check that the appliance is clean and that there are no traces of hair between the blades, as this could prevent it from working properly. Use the comb to comb the hair to be cut (16) Press the "turbo" button (4) on the rear of the appliance (1) and keep it pressed while you want to use this speed. To remove the blades (5 and 6) from the appliance (1), push the blades upwards with your thumb from the front (Fig. Next, install the required guide comb according to the desired cutting length (Fig. We recommend that you start off with one of the longest positions and change it as required. Install the shaving head (10), inserting the hook of the head in the case of the appliance. You can use this accessory to go over the contour of the beard and achieve an even result and a well-defined beard. Next, install the required guide comb according to the desired cutting length (Fig. [. . . ] When lubricating the blades, remove the guide combs (7) and the protector (8) if they are installed. Make sure that the clipper is unplugged before taking it apart to remove the batteries. All repairs and battery replacements should be carried out by an Authorized Service Shop. [. . . ]