User manual SOLAC CP7396

[. . . ] Before starting to cut Pour les cheveux courts Nuque We recommend you use the lower positions of the telescopic comb. 3 Trim the sideburns and the area around the ears in an upward direction. â· This appliance is only for domestic use, not professional use. Using it in any way other than according to the instructions could be hazardous. [. . . ] â· Children should be supervised to ensure that they do not play with the appliance. â· This appliance is not designed to be used by people (including children) whose physical, sensory or mental capacities are impaired or who lack experience or knowledge, unless they are supervised or have received instructions on how to use the appliance by a person who is responsible for their safety. Do not leave it in places where there is a danger it might fall into water. If it should fall into water, do NOT try and pick it up: unplug it immediately. In there is any problem with the cord or any other part of the appliance, do not use it and take it to an authorised service centre. â· If the power cord is damaged, it must be replaced by the manufacturer or the manufacturer's after-sales service or by similarly qualified personnel to prevent possible hazards. â· Do not use parts or accessories not supplied or recommended by SOLAC. â· Before plugging in the appliance to the mains, check that the indicated voltage matches the voltage in your home. â· Always unplug the appliance after use and before dismantling or assembling parts, and performing any maintenance or cleaning operations, except for charging the battery. When plugging in or unplugging the appliance, it must always be turned off. Place the selector (4) in position 7 and carefully push outwards until it goes past the end (Fig. To replace the telescopic comb on the hair clipper, fit the guides correctly into the guide rails and push downwards until you go past the end (Fig. 2 mm cutting accessory Blade Operating control Telescopic comb position selector Charge indicator (CP7396) Hair clipper cleaning brush Connector Adaptor (CP7318)/ charger (CP7396) We recommend you use the higher positions of the telescopic comb. 4 Begin cutting from the FRONT of the head and gradually move towards the BACK (Fig. While cutting, regularly check the position selector (4) has not accidentally moved, to avoid an uneven finish. Use the 2mm cutting accessory (1b) for a cut shorter than 4 mm (position 1 on the telescopic comb) or for a "stubbly" effect. Any repairs or battery replacements should be performed by an Authorised Technical Service. After charging, unplug the charger from the mains and then unplug the cable from the connector (7). Charging it for the first time takes 17 hours, while subsequent recharges require approximately 12 hours for 45 hours operating time. Before cleaning the clipper, check that it is switched off and unplugged. [. . . ] Shake the hair clipper in the waste bin so the hair trapped between the blades falls out. Use the brush provided to clean the blades and the inside of the hair clipper (Fig. â· Use the hair clipper until the batteries are completely flat, and then completely recharge the battery. â· Do not store or recharge the appliance close to radiators or other sources of heat, or expose it to direct sunlight. [. . . ]