User manual SOLAC EVOLUTION

[. . . ] If you observe any of these problems, take the CVG to a one service authorized by SOLAC. € Please never leave the CVG unattended while it is connected to the supply. € Children must be supervised to ensure they do not play with the appliance. € This appliance is not for use by persons (including children) whose physical, sensorial or mental capacities are impaired, or who lack sufficient experience or knowledge, unless they have been supervised or instructed in the use of the appliance by a person responsible for their safety. [. . . ] You will thus guarantee that your CVG stays in perfect condition for as long as possible. If you cannot find distilled water for any reason, be sure to use water that is low in minerals (soft). Do not put any type of scale remover solvents or products in the water tank. These products can damage the interior of the steam generation system. 2 Fill the tank without exceeding the maximum level using the beaker provided (8) and keeping the CVG upright. 3 Check the garment to be ironed to see if it has a label that indicates the ironing temperature. We recommend that you classify garments by their required ironing temperature and that you begin ironing with the garments that require the lowest temperature ( • ). sILK , WOOL , SYNTHETIC FIBRES , minimum temperature (•) POLYESTER , medium temperature (••) COTTON , max. Temperature (•••) LINEN, maximum temperature (MAX) ‹ Keep the water-filling hole lid (1) closed during operation. Z i NB: Ironing delicate garments with a temperature higher than necessary is harmful for i If you have any doubts about the temperature to use for a given garment, perform a test on a part which won’t be seen, beginning with the lowest temperature settings. Woolmark: The wool cycle of this iron has been approved by The Woolmark for the ironing of pure wool products provided that the products are to the instructions on the garment label and those issued by this iron. Steam emission is only temporarily cut off until contact is detected once again on the handle. 1 Without touching the handle, press the steam selector for 3 seconds (6) (fig. 2 Press the steam selector (5) for 3 seconds to switch on the CVG again. The CVG will be situated at Position and with the steam selector deactivated . z Z AUTOMATIC SWITCH OFF: AUTO - PAUSE The CVG has an automatic switch off system. It is switched off automatically 3 minutes after the last time it was used. This means that once the device is activated, the CVG no longer heats up and begins to cool down. All the icons on the screen will then disappear except the icon, which flickers indicating that the appliance has been switched off. To activate it again, simply take hold of the handle or touch the temperature selectors (5) or steam selector (6). A buzzer will sound and the CVG will return to the temperature and steam position selected before it was switched off. Remember that the period between being switched off and switched back on again will affect the time that the CVG may need to regain the temperature selected previously. [. . . ] 3 Press the steam selector (6) once or twice, defending on the flow of steam desired (medium or maximum ). I At Position (••) you will obtain a more humid visible steam which will be easier to see, whereas at Position (•••) and (MAX) the steam is drier and, although the same flow is maintained, will be less visible. Dry the CVG with a dry cloth if any of the water spills out of the tank. If the appliance were to run out of water completely with the steam selector activated, you would hear a strange noise from the micro-pump. [. . . ]