User manual SOLAC PV 2010

[. . . ] € Remove all elements from the inside or outside of the appliance used for protection during transport or for sales promotions, such as paper or plastic bags, plastic sheets, cardboard and stickers. En d Do not use near bathtubs, sinks, showers or other recipients containing water. € The appliance must be connected to a power socket with a suitable ground connection. € To fill the iron or top it up while ironing, please follow the instructions in the “BEFORE STARTING TO IRON” section, ensuring you first unplug the iron from the mains. [. . . ] , If, for any reason, you cannot find demineralised water, please ensure you use water with a low mineral content (soft water), or filter tap water using a water filter. , Do not use decalcifying agents or descaling products in the water tank. 1 With the iron unplugged from the mains, rotate the steam selector (10) to the closed position (fig. Fill the water tank without exceeding the maximum level, using the water beaker provided (12) and keeping the iron in the vertical position (Fig. ) When filling the tank, make sure that the water does not overflow from the water filler opening. 3 Check whether the garment to be ironed has a label indicating the ironing temperature. ) We recommend you classify the garments according to their required ironing temperature and begin with the garments ironed on the lowest temperature (•). SYNTHETIC FIBRES, minimum temperature (•) SILK, WOOL, medium temperature (••) COTTON, high temperature (•••) LINEN, MAX temperature , Always make sure the soleplate protector has been removed before starting to , NOTE: Ironing delicate garments at a temperature higher than necessary spoils the fabric and causes burnt residue to stick to the soleplate. 12 MAIN COMPONENTS , If you have any doubts about the temperature to use for a given garment, perform a test on a part, which will not be visible, beginning with the lowest temperature settings. uSE ) This appliance has been designed exclusively for ironing clothes. ) Completely remove all the elements use for transportation and packaging. SUPERSTEAM ) If you want more steam while ironing, press the button (8) two or three times, aim the supersteam at the desired area of the garment and pass the iron soleplate over it to dry it. Once the supersteam circuit has been primed, the jet of steam will be released. VERTICAL STEAM ) This allows you to remove creases from delicate garments without having to put them on the ironing board: jackets, overcoats, curtains, etc. 1 Fill the water tank as explained in the “BEFORE STARTING TO IRON” section. 2 Place the garment on a hanger, well away from other garments, people, animals, etc. N Do not discharge steam onto a garment hanging in the wardrobe or on a person. 3 Set the steam control (10) to the closed position and the temperature selector (9) to the Max position. 4 Bring the iron close to the garment, in the vertical position, (between 15 and 30 cm) and press the supersteam button (8) once only. Do not position the iron too close to the garment, because you could damage it. 5 Wait a few seconds before pressing the button (8) again, so as not to damage the garment. DRY IRONING 1 If there is water in the tank, turn the steam selector (10) to the closed position 2 Plug in the iron and set the temperature selector (9) to the desired position. [. . . ] ) Although the power cord is fitted with a 360º swivel piece, NEVER FORCE this cord when coiling it around the appliance on the first turn. SELF-CLEANING 1 2 3 4 5 6 7 8 ) It is advisable to carry out the self-cleaning operation about once a month, depending n Be careful when performing this operation, as the water and steam are very hot and can cause burns. 9 Place the iron in the vertical position and wait for it to cool completely. ) Remember that damage caused by the effects of limescale is not covered in the warranty. [. . . ]