User manual SOLAC PV2210

[. . . ] Make sure the cord does not come into contact with sharp edges or hot surfaces. Do not leave the cord hanging over the edge of a table or worktop, to prevent children from pulling it and causing the appliance to fall. If the power cord is damaged, it should be replaced by the manufacturer or by your after-sales service shop or similar qualified personnel to prevent possible hazards. [. . . ] 3 Check whether the garment to be ironed has a label indicating the ironing temperature. ) We recommend you classify the garments according to their required ironing temperature and begin with the garments ironed on the lowest temperature (· , Always make sure the soleplate protector has been removed before starting to , If you have any doubts about the temperature to use for a given garment, perform a Test on a part, which will not be visible, beginning with the lowest temperature settings. ) Completely remove all the elements use for transportation and packaging. N If the appliance is hot, handle it with care and do not touch the metal soleplate. N Never leave the iron in a horizontal position when the soleplate is hot. N Take care with the steam; do not aim it at people, animals or delicate objects. ) For very delicate garments, place a cloth between the iron and the delicate garment to Extend the cord completely and plug it into the mains. Select the desired operating temperature according to the garment you wish to iron (see "TEMPERATURE SELECTION (fig. After using the iron, set the steam selector (10) to the closed position and the temperature selector (9) to position 0. Wait until the iron is completely cold and store it in the vertical position in a safe place. ) Before using it for the first time, use the appliance to iron an old cloth or clothing, to Set the temperature selector (9) to the Max position and wait a few minutes for the iron to reach the appropriate temperature (the temperature pilot light will go out). Rotate the steam selector (10) until it is in the completely open position (fig. Do not worry if the iron gives off a little smoke when used for the first time. Reduce the temperature, several minutes must pass before the iron reaches the selected temperature. When the selected temperature is reached, the pilot light will go out (11). 1 When the pilot light (11) goes out, indicating that the desired temperature has been reached, rotate the steam selector (10) until the desired steam flow is obtained (fig. [. . . ] ) Although the power cord is fitted with a 360º swivel piece, NEVER FORCE this cord when coiling it around the appliance on the first turn. ) It is advisable to carry out the self-cleaning operation about once a month, depending N Be careful when performing this operation, as the water and steam are very hot and Wait for the pilot light to go off (11) indicating that the desired temperature has been reached. Turn the temperature selector (9) to the 0 position and unplug the iron from the mains. [. . . ]