User manual STANTON DIGIPAK PRO

[. . . ] DIGIPAK PRO OWNER'S MANUAL S T A N T O N MA G N E T I C S , I N C information@stantondj. com + 1 954- 689-8833 www. stantondj. com IMPORTANT TO SAFETY 1. Read these Instructions Keep these Instructions Heed all Warnings Follow all Instructions Do not use this apparatus near water Clean only with dry cloth Do not block any ventilation openings. Do not install near any heat sources such as radiators, hear registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] RELOOP ­ Indicates when there is a previously set loop, and that the loop is ready to be played again. SINGLE ­ Controlled by the SGL/CTN button, this indicates when the unit is set to play just one track at a time. When this is not illuminated, the CD will play continuously through all tracks. 37) 38) 39) 40) 41) 42) SET-UP A) CHECKING THE CONTENTS ­ Check that the carton contains all of the following items. · Tabletop CD player unit · User's manual · One pair RCA cable · One power cable · One fader start / relay cable B) INSTALLING THE UNIT · Place the unit on a flat, level surface. · Be sure the player is in a well-ventilated area where it will not be exposed to direct sunlight, high temperatures, or high humidity. · Try to place the unit as far as possible from Tvs and tuners, as the unit may cause undesirable interference. · The player will work normally when the unit is within 15 degrees of the vertical plane. If the unit is tilted excessively, discs may not load or unload properly, or playback may be adversely affected. · The unit's LCD screen is designed to be clearly visible within the angles shown in the figure below. Place the unit so that the LCD screen is within this visual range for optimal clarity. C) CONNECTIONS · Make sure that the unit and any other equipment in the signal chain are turned off prior to making any connections. · Connect the RCA cable to the rear of the unit and to the input on your mixer. · Connect the power cable to the rear of the unit and to a proper AC outlet. · To avoid severe damage to the unit, be sure the power is OFF when making any connections. OPERATING INSTURCTIONS OPENING AND CLOSING This operation only works when the power is turned on. Press the OPEN/CLOSE button to open or close the disc tray, or press the PLAY button and the disc tray will close automatically. If the tray is not closed after 60 seconds it will close automatically and enter pause mode. This prevents playback from being interrupted if the OPEN/CLOSE button is pressed accidentally. Stop playback by engaging cue or pause mode, and then press the OPEN/CLOSE button. LOADING DISCS Hold a disc by its edges and place on the disc tray with the label side facing up. CAUTION: Do not place foreign objects on the disc tray and do not place more than one disc on the tray at a time. Do not push the disc tray in manually when the power is off, as this may also result in malfunction and damage. SELECTING TRACKS Select the desired track by pressing the TRACK buttons to move to the previous or next track, or by holding down the TRACK buttons to change tracks continuously at a higher speed. [. . . ] NOTE: Relay play may not work properly if the audio outputs on both players are not connected to the same audio input, amplifier, or if the mixing board is not set up properly. STUTTER EFFECTS Similar to the sound of a CD skipping, this effect can be created and controlled in a variety of ways. · By storing a cue point to one of the four BANK buttons and pressing them rapidly. · By creating a seamless loop, and rapidly pressing the RELOOP button. [. . . ]