User manual STERN ELECTRONICS FLIGHT 2000

[. . . ] The appliance must not come into contact with electrical parts once it has been installed. The consumption indications on the data plate have been calculated for this type of installation. Secure the appliance to the cabinet by opening the oven door and putting 4 screws into the 4 holes of the outer frame. All parts which ensure the safe operation of the appliance must not be removable without the aid of a tool. [. . . ] This appliance conforms to the following European Economic Community directives: 73/23/EEC of 19/02/73 (Low Voltage) and subsequent amendments; - 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent amendments; - 93/68/EEC of 22/07/93 and subsequent amendments. 16 Description of the appliance Overall view GB Control panel GUIDES for the sliding racks position 5 position 4 position 3 position 2 position 1 GRILL rack DRIPPING PAN Control panel EXTENDABLE HOTPLATES knob THERMOSTAT knob SELECTOR knob HOTPLATES indicator light HOTPLATES knob THERMOSTAT indicator light 17 Start-up and use GB !The first time you use your appliance, heat the empty oven with its door closed at its maximum temperature for at least half an hour. Ensure that the room is well ventilated before switching the oven off and opening the oven door. The appliance may produce a slightly unpleasant odour caused by the burning away of protective substances used during the manufacturing process. Cooling ventilation In order to cool down the external temperature of the oven, some models are fitted with a cooling fan that blows out air between the control panel and the oven door. Once the cooking has been completed, the cooling fan remains on until the oven has cooled down sufficiently. See the Cooking advice table for cooking modes and the suggested cooking temperatures (see Cooking Modes). The THERMOSTAT indicator light indicates that the oven is heating up to the temperature set. You may do the following during cooking: - change the cooking mode by turning the SELECTOR knob - change the temperature by turning the THERMOSTAT knob - stop cooking by turning the SELECTOR knob to the “0” position. Never put objects directly on the oven bottom to avoid damaging the enamel coating. You can turn on only the smaller internal cooking zone or both the external and internal zones. The control knob allows you to choose between two power levels, which are both adjustable between a minimum value of 1 to a maximum of 9: • The lowest power level can be set by turning the knob clockwise from 1 to 9. • Turn the knob to completely (A) until you hear a slight click, to enable the maximum power level, which in turn can be adjusted between 9 and 1 by turning the knob anticlockwise. To restore the minimum power level, turn the knob and set it back to position 0. For double cooking zones, the first part of the knob movement activates the smaller cooking zone (internal). To activate both (internal and external), it is necessary to turn the knob completely (A) and then select the desired power level between 9 and 1. The glue that is applied on the gaskets leaves some traces of grease on the glass. Before using the appliance, we recommend you eliminate these with a special non-abrasive cleaning product. During the first few hours of use there may be a smell of rubber which will disappear very quickly. To obtain the best results with your hob: • Use flat-bottomed pans to ensure that they adhere to the cooking zone perfectly. Extendable cooking zones • Always use pans with a diameter that is large enough to cover the hotplate fully, in order to use all the available heat. [. . . ] • The accessories can be washed like everyday crockery (even in your dishwasher). If the oven is fitted with self-cleaning panels, these will have to be temporarily disassembled. Cleaning the oven door Clean the glass door using non-abrasive products and sponges and dry it with a soft cloth. Replace the screws A with the screws and spacers (B + C) supplied with the kit. [. . . ]