User manual STRONG SRT 4012 BROCHURE

[. . . ] Heat Warnings - Read carefully and follow all warning labels on the product and those described in the instructions. Follow Instructions- Follow all instructions provided with this product. Cleaning - Always unplug this product from the wall outlet before cleaning. Never use any type of liquid or aerosol cleaner, or any type of organic solvent to clean this product. [. . . ] 5 English PART 1 · English 2. 0 CONNECTION 2. 1 Connecting to Terrestrial Antenna 2. 2 Connecting to TV and VCR 2. 3 Connecting to a Digital Audio Amplifier Connect your Digital Audio Amplifier with the S/PDIF connector on the back of the receiver (Fig. To receive the broadcast signal, the terrestrial antenna cable should be connected to the ANT IN connector at the back of the receiver. USB Connects to USB device TV SCART To connect your receiver with your TV set using a SCART cable. Power Cord Your receiver requires a voltage of 220 ­ 240 V AC (Autoselectable), 50/60 Hz ± 5 %. Make sure to check the power specification before connecting your receiver to the wall outlet. 3. 3 Remote Control Fig. MENU Opens the main menu/In menu you will get one step back 6 PART 1 · English 7. pq Exits from the menu or sub-menu Menu Off: Change channel to previous/next. COLOURED BUTTONS for Teletext functions 4. 0 FIRST TIME INSTALLATION If you use the receiver for the first time, the "Easy Install" menu appears. Use the tu buttons to change settings for setup of Region, OSD Language and Antenna Power and the pq to select. Then use the pq buttons to move focus to Search and press OK to proceed with the automatic channel scan. 5. 0 MAIN MENU 5. 1 Channel In viewing mode always press MENU to enter the Main Menu. It consists of following submenus: Channel, Installation, Setup, Tools and Media+ 1. Press pq buttons to highlight desired menu and press OK button to enter the setting menus. Now you can select desired setting by pq buttons and confirm it with OK. 10 PART 1 · English 5. 3. 1 OSD Language 5. 3. 2 TV System This menu allows to setup different settings concerning your TV set. Display Mode: PAL/NTSC/AUTO Aspect Ratio: Use this menu to configure the screen aspect between: 4:3 PS (Pan&Scan), 4:3 LB (Letter Box) and 16:9 (Wide Screen) Video Output: Use this menu to switch the video output mode either to RGB or to CVBS English This menu allows you to set OSD Language. 5. 3. 3 Region and Time Here you can set your region and time zone. The options are: Off / User Define / By Region GMT Offset: This menu is valid only when selected "User Define" in GMT Usage menu. The GMT offset range is "-11:30 ~ +12:00", increasing by half hours progressively. Date/Time: "Date" and "Time" menus are valid only when selected "Off" in GMT Usage menu. This menu allow to control whether the time is displayed on Time Display: screen or not. The options are: Off/On. 5. 3. 4 Timer Setting In this menu you can set a programme timer or sleep timer. Programme timer Timer Number: You can set 8 timers Timer Mode: Off/Once/Daily/Weekly/Monthly Timer Service: TV Service/Radio Service Wake-up Channel: You can select a desired channel as wake-up channel. Month/Date/Day: Press pq buttons to select your desired month, date and day. [. . . ] Input a correct password using the numeric buttons (the default password is "0000"), a confirmation window is displayed. Select "Yes" to return back to factory settings and clear all channels. Enter "Tools" menu, select "Software Upgrade" and press OK button, Software Upgrade menu is shown. Press pq buttons to select the desired item and press OK button, you are asked to input password. [. . . ]