User manual STRONG SRT 4356 PDR

[. . . ] Heat Warnings - Read carefully and follow all warning labels on the product and those described in the instructions. Follow Instructions- Follow all instructions provided with this product. Cleaning - Always unplug this product from the wall outlet before cleaning. Never use any type of liquid or aerosol cleaner, or any type of organic solvent to clean this product. [. . . ] Be aware: after pressing BLUE button channel(s) will be deleted from all channel lists. Press EXIT to cancel or OK to confirm. 5. 2 Satellite Search The Satellite Search menu contains following sub-menus: n Channel set-up allows you to setup channels from selected satellites. n Edit satellites allows you to edit predefined satellites and their transponders as well as add new satellites. n GOTO X setup allows you to setup your location in order to use GOTO X type of positioner. 5. 2. 1 Channel set-up From this menu you can setup channels from satellite(s) in several modes, access to Dish setup menu, Positioner setup (if used). If satellite doesn't exist in the list you should add it first using Edit satellites menu. Use tu buttons to select dish number to which above selected satellite belongs to. Dish number "----" means that selected satellite do not belongs to any dish. If mode of selected dish is DiSEqC 1. 2 then value cannot be stored (in case dish position for selected satellite was not stored) or in range from 1 to 64 if position has been stored. List of transponders of selected satellite will appear at right side of the screen. You can select transponder in order to check signal strength and quality of reception. n Select reference transponder in order to check signal strength and quality during position setup. n If you do not know current direction of your dish then move menu focus to Centre position item and press OK. Knowing your location longitude you may understand direction where necessary to move dish in order to reach position of selected satellite. For example: your longitude is 5° East and you want to setup dish position for Astra 1C, 1E (19° East). Then, from centre position, you need to move dish to East direction by pressing to t button. If your longitude is 25° East then, in order to setup dish position for Astra 1C, 1E (19° East), you need to move dish in West direction (from centre position) by pressing to u button. Then move menu focus to Move item of the menu and by short presses to t or u buttons move dish to necessary direction. Set Movement speed to Slow and keep adjusting dish position until get best possible values. n Once you are sure that dish is fine adjusted press YELLOW (Store) or BLUE (Store & Exit) button. NOTE: in order to avoid mechanical damage of your dish please, make sure those mechanical limits in your motor are set correctly and dish would not hit any objects on its movement. 17 English PART 1 · English 5. 2. 2 Dish set-up In this menu you can setup parameters of your dish(es). This number used in Channel setup menu to create a link between satellite and corresponded dish configuration. [. . . ] Recording Info banner appears and shows the file name, recording time and duration (which can be adjusted in Application > PDR menu). During recording you can call up the Record Channel List by pressing the OK button to watch another Free-To-Air channel within the same transponder. If you want to delete recorded file(s) from the Recording File List press the RED (delete) or GREEN (All delete) button. Press Ñ (Play) button in TV mode and the Recording File List will appear on screen. [. . . ]