User manual SUNBEAM H2O WATER DISPENSER

[. . . ] place the water dispenser away from direct sunlight And make sure that there is at least 4 inches of space between the back of your unit and the wall. Refrigeration system and heating system: parts and labor; two years warranty from the date of original purchase at retail (see enclosed detailed warranty form). If you are unable to locate the problem, please call our toll free number 1-877-383-6399 for assistance. For warranty repair, trouble-shooting and maintenance tips p lease obtain the authorization for return and the address of the nearest service center, by calling the same toll free number. [. . . ] We recommend that in order to fully enjoy the desired water setting, you should eliminate this small amount, 200ml - 400ml (6. For the cold water, there is a 304 stainless steel water cooling tank. For the hot water there is a 304 stainless steel heavy duty hot water tank with an external heater. State-of-the-art digital display The front panel has three indicator lights, to see if the power, heating and refrigeration are on. From the left, the first two digits display the HOUR, the next two digits display the MINUTES and the last two digits display the SECONDS. On the LED display the first two digits on the left side, indicating the Hour, will start flashing. pressing the Adjust button the number on the flashing digits will increase. On the LED display the third and fourth digits from the left side, indicating the minutes, will start flashing. pressing the ADJUST button the number on the flashing digits will increase. On the LED display the sixth and seventh digits from the left side, indicating the seconds, will start flashing. pressing the ADJUST button the number on the flashing digits will increase. To switch back and forth from degrees Fahrenheit to Celsius temperature display, while being in Temperature Display Mode or Temperature Setting Mode, press ADJUST button and TEMPERATURE Mode simultaneously for 5 seconds. Press Temperature button one time to enter Temperature Display Mode and a second time to enter Temperature Setting Program Mode. On the LED display the actual temperature settings will be displayed and, the first two digits on the left side, indicating the COLD WATER, will start flashing. Keep the ADJUST button pressed until the desired temperature is displayed. On the LED display the third and fourth digit from the left side (indicating the cooling compartment temperature) will be flashing. Keep the ADJUST button pressed until the desired temperature is displayed. On the LED display in fahrenheit, the fifth, sixth and seventh digits from the left side, indicating the hot water temperature, will start flashing. Keep the ADJUST button pressed until the desired temperature is displayed. the range is approximately between 158°F (70°C) to 194°F (90°C). [. . . ] If the water dispenser is noisy after its first use, unplug the water dispenser for a 1/2 hour, then start it up again. If you are not satisfied with the water dispenser performance check if there is enough room around the water dispenser to provide ample ventilation. Once the compressor has stopped, gradually readjust the cold water setting and then the cooling compartment. When the cooling compartment is loaded and the compressor is running continuously while the bottled water is not consumed, there can be an overcooling of the cold water tank. [. . . ]