User manual TEKA CB 380

[. . . ] · Your kitchen hood is designed for domestic use and only for extraction and purification of fumes produced during food preparation. It will be your responsibility if it is used for other purposes, which may be dangerous. The manufacturer cannot accept responsibility for damage caused by improper use of the appliance. · For repairs please contact the nearest TEKA Technical Assistance Service, and always use genuine spare parts. [. . . ] · For repairs please contact the nearest TEKA Technical Assistance Service, and always use genuine spare parts. Repairs or modifications carried out by unqualified personnel can cause malfunctions or may damage the appliance, putting your safety in danger. · This appliance is marked according to the European directive 2002/96/EC on "Waste Electrical and Electronic Equipment" (WEEE). This guideline is the frame of a European-wide validity of return and recycling on Waste Electrical and Electronic Equipment, . · When the cooker hood is run at the same time as other than electrical appliance or equipment with different energy source, the air extraction (underpressure) must no be higher than 4Pa (4 x 10-5 bar). ENG 10 Index Page Description of the appliance Instructions for use Cleaning and maintenance Problem solving Sizes and specifications Accessories supplied Installation Active charcoal filters 11 11 12 12 12 13 13 13 Instructions for use You may control the kitchen hood by operating the controls as shown in the diagram. Minimum speed Medium speed Maximum speed Extra fan Filter saturation indicators Timer Reduce speed Increase speed On-Off Power indicator Description of the appliance A An electronic programmer device with TOUCH CONTROL technology to control speed, light, programming and power indicators in use as well as filter saturation. Vertically adjustable tubecovers. Switch on the extractor fan a few minutes before you start to cook in order to ensure that a steady air flow has been established before fumes appear. Allow the extractor fan to run for several minutes after you have finished cooking (between 3 to 5 minutes) in order to expel all the grease from the outlet duct. Programming timer Proceed as follows: 1) Turn the kitchen hood on and choose the required speed. 3) Select the required time by pressing the increase and decrease speed selectors. 4) Once the required time has been selected, press "timer" again to memorise the program. supplied) to (B) or on to the motor's air outlet vent as the case may be. 1 (Page 31) tubecover around the extractor fan outlet and On installing the kitchen hood make sure attach the upper tubecover with the screws (G) that the Safety Instructions set out on page (Ø3, 9 x 13). To obtain optimum performance, the external Active charcoal filters (Optional) conduct must not be more than FOUR When exterior gas extraction is not possible, METRES long, have no more than two 90° angles and its diameter must be at least Ø120. then the kitchen hood may be set to purify the air by recycling it through active charcoal filters. 1) Trace and drill the points for fitting the wall plugs onto the wall (P) (Ø8 x 40) and (J) (Ø6 x The active charcoal filters have an active life of between three to six months, depending on 30). These filters 2) Attach the Supports (O) to the wall using the cannot be washed nor regenerated. They must long bolts (Q) (Ø5 x 45) and the support (H) be replaced once their useful life comes to an with the long bolts (I) (Ø4 x 30), as in figure 1. Loosen the screws (without unscrewing them) of the EASYCLEAN (without unscrewing them) of the EASYCLEAN panels (A19), move the panels aside carefully panels (K), move the panels aside carefully and take them off. 5) Trace the location of the wall plugs (R) (Ø8 2) Put the filters into the lateral draught section x 40), through the inside of the kitchen hood. of the motor making the holes in the filters match up (A) with the pivots (B) of the motor 6) Take the kitchen hood off. [. . . ] Loosen the screws (without unscrewing them) of the EASYCLEAN (without unscrewing them) of the EASYCLEAN panels (A19), move the panels aside carefully panels (K), move the panels aside carefully and take them off. 5) Trace the location of the wall plugs (R) (Ø8 2) Put the filters into the lateral draught section x 40), through the inside of the kitchen hood. of the motor making the holes in the filters match up (A) with the pivots (B) of the motor 6) Take the kitchen hood off. 7) Drill into the wall and fit the wall plugs (R) 3) Mount the EASYCLEAN panel again (K). [. . . ]