User manual TEKA DT-90 VERSION 0.1

[. . . ] The fat accumulated in the filters may drip or catch fire when the temperature increases. · Avoid cooking under the kitchen hood if the metal filters are not fitted, e. g. : while they are being cleaned in the dishwasher. · Disconnect the appliance before any interior manipulation, e. g. [. . . ] Once you have cleaned the filters, and with the hood turned off, press the increase and decrease speed buttons at the same time for 3 seconds and the indicator will switch itself off. 11 ENG Cleaning and maintenance During cleaning and maintenance work, make sure the safety instructions set out on page 10 are complied with. Cleaning the hood body · If your kitchen hood is made from stainless steel, use proprietary cleaners mentioned in the product instructions. · If your kitchen hood is painted, use lukewarm water and a neutral soap. · Never use metallic scourers, nor abrasive or corrosive products. · Dry the kitchen hood using a cloth that does not produce fibres. Cleaning the metal filters To remove the filters from their fittings, press lightly on the locks and then pull them off. The metal filters can be cleaned by soaking them in hot water with neutral detergent until the fat dissolves and then rinsing them under the tap or using special anti-grease products. In this case, it is advisable to stack them vertically to avoid food residues to stick to them. Cleaning in a dishwasher may damage the metallic surface (blackening it), although this will not affect its fat retention capacity. Once clean, leave them to dry off and then fit them onto the kitchen hood. Loosen the screws (without unscrewing them) of the EASYCLEAN panels (K), move the panels aside carefully and take them off. Fit the metal filters. ENG _________________________________________________________ Problem solving Proceed with the following checks before calling the Technical Service: Sizes and specifications See page 30. reserves the right to make changes and corrections to its products as it deems necessary, without altering their basic characteristics. 10) Mount the tubecovers, attaching the lower one to the support (H) as per the detail in figure 2 Wall support. [. . . ] Fit the diffuser (M) (M4 x 12) with the washers (A3) (Ø6, 4 x (C) on to the motor's air outlet vent. Fit the Ø12) and the long bolts (S) (Ø5 x 45) with the tubecovers back on (E). Accesories supplied 13 ENG 30 1 2 3 31 TEKA GROUP COUNTRY Austria Belgium Chile China Czech Republic France Greece Hungary Indonesia Malaysia Mexico Poland Portugal Russia Singapore Thailand The Netherlands Turkey U. [. . . ]