User manual TEKA HM-815 ME INSTALATION MANUAL

[. . . ] Ventilation To ensure adequate ventilation is provided, the back panel of the cabinet must be removed. It is advisable to install the oven so that it rests on two strips of wood, or on a completely flat surface with an opening of at least 45 x 560 mm (see diagrams). GB Positioning  Keep all packaging materials out of the reach of children. it may present a choking or suffocation hazard (see Precautions and tips). [. . . ] To deactivate the DEMO mode, while the oven is switched on press the ON/OFF button and the time “-” button on the right hand side of the control panel. The DEMO mode can only be activated when the oven is switched on and no cooking programme has been commenced. Setting the clock  The clock may be set when the oven is switched off or when it is switched on, provided that a delayed cooking cycle has not been programmed previously. Press the button several times until the icon and the two digits TIME display flash. 21 GB If a blackout occurs while the oven is already in operation, an automatic system within the appliance will reactivate the cooking mode from where it was interrupted as long as the temperature has not dropped below a certain level. Programmed cooking modes which have not started will not be restored and must be reprogrammed.  Never put objects directly on the bottom of the oven; this will avoid the enamel coating being damaged. Cooling ventilation In order to cool down the external temperature of the oven, a cooling fan generates a stream of air which escapes between the oven control panel and the oven door.  Once the cooking has been completed, the cooling fan continues to operate until the oven has cooled down sufficiently. Oven light When the oven is not in operation, the lamp can be switched on at any time by pressing the button. 22 Cooking modes Manual cooking modes  All cooking modes have a default cooking temperature which may be adjusted manually between 40°C and 250°C as desired. Programming the duration To set the duration of a manual cooking mode 1. Press the button several times until the icon and the first digit on the TIME display flash. Press the "+" and "-" buttons to adjust the hour value. Press the "+" and "-" buttons to adjust the minute value. Programming delayed cooking  A cooking duration must be selected before delayed programming can take place. Then press the button until the icon and the two digits on the TIME display flash. Press the "+" and "-" buttons to adjust the hour value. Press the "+" and "-" buttons to adjust the minute value. And a time of 1 hour and 15 minutes is programmed and the end time is set to 12:30. The TIME display shows the cooking end time and the cooking duration alternately. : Practical cooking advice  Do not place racks in position 1 and 5 during fanassisted cooking. [. . . ] 27 Care and maintenance GB Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. F Cleaning the appliance • The stainless-steel or enamel-coated external parts and the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. • The inside of the oven should ideally be cleaned after each use, while it is still lukewarm. Use hot water and detergent, then rinse well and dry with a soft cloth. [. . . ]