User manual TP-LINK TL-PA2015PKIT

[. . . ] No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO. , LTD. All rights reserved. http://www. tp-link. com FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. CE Mark Warning This is a class B product. Connecting the PoE Receiver Adapter You can use TL-PA2015PKIT PoE Receiver Adapter with PSE or PoE Supplier Adapter to expand your network to where there are no power lines or outlets, where you wish to fix devices such as APs, IP Cameras or IP Phones, etc. The following steps will tell you how to connect the PoE Receiver Adapter correctly. 3 1. Choose the appropriate DC output by the Power-mode Switch, default output is 12V. Note: Please make sure that the output is correct, different voltage may destroy the device. Connect the LAN OUT port to the Ethernet device with CAT5 UTP cable for data transmitting. Connect the DC OUT port to the power port of the same Ethernet device with the provided power cable. [. . . ] Connect the LAN OUT port to the Ethernet device with CAT5 UTP cable for data transmitting. Connect the DC OUT port to the power port of the same Ethernet device with the provided power cable. [. . . ]