User manual TP-LINK TL-WR841N

[. . . ] 0 1910010635 COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO. Com FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ] IP Address - The IP Address of the PC providing the service application. Protocol - The protocol used for this application, either TCP, UDP, or All (all protocols supported by the Router). Click the Add New… button, the next screen will pop-up as shown in Figure 4-33. Select the service port you want to use from the Common Service Port list. If the Common Service Port list does not have the service that you want to use, type the service port number or service port range in the Service Port box. Select the protocol used for this application, either TCP, UDP, or All. - 47 - TL-WR841N/TL-WR841ND 300Mbps Wireless N Router User Guide Figure 4-33 Add or Modify a Virtual Server Entry Note: If your computer or server has more than one type of available service, please select another service, and enter the same IP Address for that computer or server. Click the Enable/Disabled All button to make all entries enabled/disabled. Click the Next button to go to the next page and click the Previous button to return the previous page. Note: If you set the service port of the virtual server as 80, you must set the Web management port on “Security → Remote Management” page to be any other value except 80 such as 8080. 2 Port Triggering Choose menu “Forwarding → Port Triggering”, you can view and add port triggering in the screen as shown in Figure 4-34. Some applications require multiple connections, like Internet games, video conferencing, Internet calling and so on. Port Triggering is used for some of these applications that can work with an NAT Router. - 48 - TL-WR841N/TL-WR841ND 300Mbps Wireless N Router User Guide Figure 4-34 Port Triggering Once the Router is configured, the operation is as follows: 1. A local host makes an outgoing connection using a destination port number defined in the Trigger Port field. The Router records this connection, opens the incoming port or ports associated with this entry in the Port Triggering table, and associates them with the local host. When necessary， the external host will be able to connect to the local host using one of the ports defined in the Incoming Ports field. Trigger Protocol - The protocol used for Trigger Ports, either TCP, UDP, or All (all protocols supported by the Router). Incoming Ports - The port or port range used by the remote system when it responds to the outgoing request. A response using one of these ports will be forwarded to the PC that triggered this rule. Incoming Protocol - The protocol used for Incoming Ports Range, either TCP or UDP, or ALL (all protocols supported by the Router). Click the Add New… button, the next screen will pop-up as shown in Figure 4-35. [. . . ] Setting IP address manually 1 2 Select Use the following IP address radio button. And the following items available If the Router's LAN IP address is 192. In the Preferred DNS Server field you can enter the same value as the Default gateway or type the local DNS server IP address. MIMO uses multiple transmitter and receiver antennas to allow for increased data throughput via spatial multiplexing and increased range by exploiting the spatial diversity, perhaps through coding schemes like Alamouti coding. [. . . ]