User manual TREK BIKES SENSOR 1998
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual TREK BIKES SENSOR 1998. We hope that this TREK BIKES SENSOR 1998 user guide will be useful to you.
Manual abstract: user guide TREK BIKES SENSOR 1998
Detailed instructions for use are in the User's Guide.
[. . . ] Trek Sensor Cycling Computer Owners Manual
Congratulations and thank you for purchasing the Trek Sensor Cycling Computer. Before operating please read this instruction manual carefully and retain it for future reference. We recommend setting the speed scale and wheel circumference before installing the computer. [. . . ] Installing/Replacing the battery.
Remove the battery cover by using a narrow flat blade or similar opener as illustrated in fig. Insert a new battery (3v) CR2032, position the (+) pole upward as illustrated. Place the battery properly into the case and close the cover securely. After the battery is installed speed scale and wheel size can be set.
3. Setting Speed Scale Choose KM for Kilometers or Miles.
After the battery is installed all displays will be illuminated, then "KM"
Page 2 Page 3
fig 5
fig 4
alone will remain flashing on the screen as in fig. When desired choice is on screen pull magnet away from wheel sensor to lock choice and move on to next step. Tighten spoke screw so that it cinches the magnet securely to the spoke. The magnet should line up with indent on wheel sensor.
Spoke Channel Spoke Screw
Odometer (total distance) (0. 0-9999 kms or 6213 miles)-ODO
The total distance is continuously measured, accumulated and displayed until next reset or the battery is changed. When 9999 kms or 6213 miles is reached the odometer returns to zero and counting begins anew.
Trip Distance (0. 0-999. 9 kms)-DIS
The trip distance from start to current point is displayed. Trip distance will start calculating if signal is received, and stop calculating when signal stops.
Auto Start/Stop Test
Mount the computer in the bracket. Lift the front wheel off the ground and spin the wheel checking if current speed is displayed. If not, adjust wheel magnet and wheel sensor as described in installation steps 9. Refer to the following steps for the operation of your Sensor computer. All functions - Current Speed(S), Odometer(ODO) and Trip Distance(DIS) will automatically start and stop when signal is received or stopped.
Auto Scan
All the functions (ODO, DIS) will automatically scan and each display mode will last 3 seconds. [. . . ] 8" and re-adjust correctly.
-20. 0 C to 50. 0 C (-40 F to 122. 0 F) 100mm-2999mm Approx. 1 year
Are the marking lines of the Refer to "installation fig. Replace the bracket wire & wheel sensor with a new one.
©1999 Trek Bicycle Corporation. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE TREK BIKES SENSOR 1998
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual TREK BIKES SENSOR 1998 will begin.