User manual TRONIC KH 3108

[. . . ] The power station can provide a jump start in case of problems starting the engine caused by too low battery capacity. ⷠThe jumper cable with the pole clamps can be found on the side of the unit. [. . . ] The power station is equipped with a maintenance-free storage battery, which is only partially charged when delivered. Charge the storage battery completely before using for the first time. Use only the accessories delivered with the battery for charging purposes. You can charge the power station with the power supply unit or the automobile adaptor cable. Insert the connection cable of the accompanying power supply unit in the device's loading jack "RECHARGE" (Fig. Charging the Power Station with the Vehicle Adaptor Cable The power station can be charged with the accompanying vehicle adaptor cable by means of a vehicle cigarette lighter. Only charge the power station while driving, as otherwise the unit will run down the vehicle's battery. Never start the vehicle as long as the automobile adaptor cable is connected to the cigarette lighter socket; this is a fire hazard. Insert the 12V plug of the accompanying automobile adaptor cable into the automobile's cigarette lighter and the other end of the cable into the charging jack of the power station marked "Recharge. Have a defective device repaired by our customer service before operating it again!Otherwise, it is possible that the power station could no longer be sufficiently safe!- Do not try to repair a defective device yourself ­ if you yourself are not a specialist. - When using the power supply unit, connect the power station only to a 230V (~50Hz) electrical socket. ⷠChildren cannot evaluate the dangers that can arise through the use of electrical equipment. [. . . ] Secure the connector piece by flipping back the locking lever (Fig 2 / Item 2). Be sure to switch off the power station and to disconnect all devices before performing cleaning or maintenance work. [. . . ]