User manual US ROBOTICS 3CP5613

[. . . ] Robotics, and Winmodem are registered trademarks and Connections, RapidComm, and x2 are trademarks of 3Com Corporation. Any other trademarks, trade names, or service marks used in this manual are the property of their respective owners. In accordance with the ITU-T standard for 56K transmissions (V. 90), U. S. However, due to FCC rules which restrict power output of service providers, current download speeds are limited to 53 Kbps. [. . . ] If there are no IRQs available, you may have to remove, disable, or relocate another device in order to free an IRQ for use by your modem. Refer to that device's documentation for more information about removing, disabling, or relocating it. Possible solution: You may be using a COM port address that is either already in use or not configured correctly. Windows 95/98 Make sure your COM port is not already in use by another device. Click Windows Start, Settings, and Control Panel, and then double-click Modems. If there is another modem installed, click the Diagnostics tab to find out which COM port it is using. If a previously installed modem is already using the available COM port, you should uninstall that modem. See your previous modem's manual for uninstallation instructions. If the Communications Ports have yellow exclamation points or red Xs over them, your COM ports may be configured incorrectly. If this is the case, you may need to contact your computer manufacturer. 6-29 TROUBLESHOOTING AND HELP RESOURCES Windows NT Turn off your computer and remove your modem. Your modem must be jumpered to a COM port setting that does not appear in this list. Possible solution: Your communications software may not function properly if you have more than one version of the software installed, you are using an older version, or you have more than one communications software installed on your system. We highly recommend using the communications software provided with your modem on the Connections CD-ROM. Possible solution: Your software's port settings may be incorrect. There should be a place in the Setup section of your software that addresses port settings. Make sure the software's port settings match those for your modem. See the Installation Guide that came with your modem for an explanation about how to determine your modem's port settings. Check your communication software's documentation for instructions on adjusting the port settings in your software. Possible solution: You may not have the correct modem type selected in your software or in Windows. You can also add, remove, or view the properties of modems from this window. Robotics modem you have installed should be present in the list of installed modems. [. . . ] Le matériel doit également être installé en suivant une méthode acceptée de raccordement. L'abonné ne doit pas oublier qu'il est possible que la conformité aux conditions énoncées cidessus n'empêche pas la dégradation du service dans certaines situations. REGULATORY INFORMATION AND LIMITED WARRANTY Les réparations de matériel homologué doivent être coordonnées par un représentant désigné par le fournisseur. L'entreprise de télécommunications peut demander à l'utilisateur de débrancher un appareil à la suite de réparations ou de modifications effectuées par l'utilisateur ou à cause de mauvais fonctionnement. Centre de guarantie et de service après-vente: Keating Technologies 25 Royal Crest Court, Suite 120 Markham, ONT L3R 9X4 Customer on and after January 1, 1998 that is date sensitive will continue performing properly with regard to such date data on and after January 1, 2000, provided that all other products used by Customer in connection or combination with the 3Com product, including hardware, software, and firmware, accurately exchange date data with the 3Com product, with the exception of those products identified at 3Com's Web site, http://www. 3com. com/products/yr2000. html as not meeting this standard. [. . . ]