User manual US ROBOTICS USR2249 QUICK START

[. . . ] 22 Mbps Wireless Access Point Quick Installation Guide Note: For the most updated information, visit: http://www. usr. com/ support. Robotics Installation CD-ROM for more detailed information. Prepare for installation Turn on your desktop or laptop computer. [. . . ] Follow the on-screen instructions and wait for some files to be copied to your hard drive. A window will appear showing you the files that are being loaded onto your system. When you are prompted to reboot your computer, select Yes, I want to restart my computer now and click Finish. After your computer reboots, the program window with the Configuration Utility icons may appear. Remove the Installation CD-ROM and prepare to install your hardware. Connect the 22 Mbps Wireless Access Point · · Use the Ethernet port and an RJ-45 cable to connect the 22 Mbps Wireless Access Point to one of the following devices: a cable or DSL modem with routing capabilities, a hub, a bridge, an existing Ethernet LAN, or a router. Attach the power supply to the Wireless Access Point and to a power outlet. The Wireless Access Point has three LED status indicators, LINK, DATA, and POWER. When the Wireless Access Point is plugged in, the PWR LED will illuminate. When there is network activity, the DATA LED will be yellow. Verify detection of the 22 Mbps Wireless Access Point After the Wireless Access Point is installed, double-click the icon for the Configuration Utility on your desktop. If the 22 Mbps Wireless Access Point is correctly installed, the configuration information will be displayed. To verify that you are connecting to the correct Wireless Access Point, check the MAC address. The MAC address is located on the bottom of the 22 Mbps Wireless Access Point case and in the Link Information option of the Configuration Utility. When you have identified the correct Wireless Access Point, note the IP address that is listed. Launch a Web browser on the computer that is physically connected to the 22 Mbps Wireless Access Point. There is no default username or password, so just click OK when you are prompted. [. . . ] You should now be able to connect your Wireless Access PC Cards and PCI Adapters to the Wireless Access Point. For more detailed information about the installation procedure, the Access Point Web Configurator, Troubleshooting, and Technical Support, refer to the User Guide on the Installation CD-ROM. Printed in Taiwan [. . . ]