User manual US ROBOTICS USR9000 INSTALL GUIDE

[. . . ] Robotics Corporation 935 National Parkway Schaumburg, Illinois 60173-5157 USA No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation, or adaptation) without written permission from U. S. Robotics Corporation reserves the right to revise this documentation and to make changes in the products and/or content of this document from time to time without obligation to provide notification of such revision or change. Robotics Corporation provides this documentation without warranty of any kind, either implied or expressed, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose. If there is any software on removable media described in this documentation, it is furnished under a license agreement included with the product as a separate document, in the hard copy documentation, or on the removable media in a directory file named LICENSE. TXT or !LICENSE. TXT. [. . . ] In a case of a resource being under the required value, update your computer to the recommended resource level. · · · · Review the Troubleshooting Checklist at the beginning of this section. If a second USB port is available on your computer, try connecting the USB cable into that USB port. If the USB device is not recognized, check the computer manufacturer's documentation. If applicable, confirm that the USB cable is plugged into a powered USB port. Powered USB ports are normally located directly on the back panel of the computer and not on the keyboard. · I ran a test using the U. S. Robotics SureConnect ADSL utility, and the Internet Connection Test failed. The modem was able to connect to the telephone company but was unable to reach the Internet Service Provider (ISP). There may be a problem connecting to the Domain Name Service (DNS) maintained by the Internet Service Provider. · · · · Click Windows Start, select Settings and click Control Panel. The Modem test will fail if the computer is unable to communicate with the modem or if the modem does not successfully complete the self-test. Take the following steps to ensure your computer can communicate with the modem: 18 · · When the setup is launched, click Uninstall and select Yes if asked to confirm the uninstall. Then try to reinstall the modem. Technical Support · When I complete my installation the Test tab of the U. S. Robotics SureConnect ADSL utility displays and I can't surf the Internet. Click the Test button in the Test tab to initiate a test on the modem. The cause of the failure will be identified in the lower half of the screen. While trying to surf the Internet, I received a "Page Not Found" or similar error. Your computer may not have acquired an IP address from your provider's DHCP server when you established the dial-up connection. Disconnect your dial-up connection, and then reconnect it to force a new request. The drivers are installed, the PWR LED is on, the phone line is connected, but the ADSL LED is off or keeps flashing. · · Review the Troubleshooting Checklist at the beginning of this section. Unplug the USB cable from the modem for two to three minutes, but leave the phone line connected. [. . . ] Robotics sole obligation under this express warranty shall be, at U. S. Robotics' option and expense, to refund the purchase price paid by Customer for any defective software product, or to replace any defective media with software which substantially conforms to applicable U. S. Customer assumes responsibility for the selection of the appropriate applications program and associated reference materials. Robotics makes no warranty or representation that its software products will meet Customer's requirements or work in combination with any hardware or applications software products provided by third parties, that the operation of the software products will be uninterrupted or error free, or that all defects in the software products will be corrected. [. . . ]