User manual VIETA VTD50 BROCHURE

[. . . ] sticky residue (P . 6). **** ******* ******* ******* ******* ************** ******* ******* ******* P1 . . 2). Do not expose the discs to direct sunlight or heat sources such as hot air-ducts, or leave them in a car parked in direct sunlight where there can be a considerable rise in temperature inside the car (P . 3). Do not use your CDs with labels or stickers attached. Labels are attached (P . 7). ******* ******* ******* ******* ******* P7 . Do Not Use Special Shape CDs Be sure to use round shape CDs only for this unit and do not use any special shape CDs. Use of special shape CDs may cause the unit to malfunction. (P . 8). P3 . [. . . ] The reset button is to be activated for the following reasons: Initial installation of the unit when all wiring is completed. Note: If press RESET button, the unit still cannot function normally, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the control panel. BR - 6 6. AUDIO OPERATIONS 2) ENCODER VOLUME KNOB Turn this knob to adjust desired volume level. 3) AUDIO SELECT BUTTON Press this button to select desired audio function. ORDER OF FUNCTION: VOL->BASS (BAS)->TREBLE (TRE)->BALANCE (BAL)-> FADER (FAD) While the selected function is displayed, turn Volume Knob to adjust the level within 5 seconds, otherwise the unit will return to volume adjustment mode. 7) PRESET EQUALIZER BUTTON (PEQ) Press this button to toggle the following EQ setting: FLAT->CLASSICS->POP M->ROCK M->DSP OFF At DSP OFF mode, EQ will be controlled by Bass/Treble setting. 15)BAND/LOUDNESS BUTTON (BAND/LOUD) Press the Band/Loudness Button long to switch the loudness on or off. When Loudness is on, display will show 'Loud On' for a few seconds. BR - 7 7. RADIO OPERATIONS 9) RADIO SIGNAL STRENGTH METER (RSLM) This is use to indicate the signal strength of current radio station broadcast. When you choose RADIO mode, it will show on the display. Best reception Worst reception 10) AUTO MEMORY STORE/PRESET SCAN BUTTON (AS/PS) 1. PRESET SCAN: Press AS/PS button briefly to enter Preset Scan mode, it will scan all the preset stations in the memories, you can hear that it will stay on each station for about 5 seconds. 2. AUTO MEMORY STORE: Press AS/PS button for couple of seconds to enter Auto Store mode, this feature will automatically scan the current band and enter up to 6 strongest stations into the 6 preset memories. 7) STATION PRESET BUTTONS (M1-M6) 1. Press these buttons briefly to recall the stored stations in the selected band. M1) PAUSE BUTTON ( ) Press this button to pause CD play, press again to release pause. M2) SCAN BUTTON (SCN) Press this button, the first 10 seconds of each track will be played sequentially until this button is pressed again, then normal play will resume at the current track. M3) REPEAT BUTTON (RPT) Press this button, the current track will be played repeatedly until this button is pressed again. M4) RANDOM BUTTON (RDM) Press RANDOM BUTTON (RDM) during disc play to play all tracks on a CD in random, shuffled order. 8) TRACK UP AND TRACK DOWN BUTTON Press the Track Up Button to skip to the next track or previous track. Press the Track Down button during play will return to the beginning of the current track, press it one more time to skip to previous skip. The receiver will switches to radio mode automatically. BR - 12 PLEASE READ THIS INSTRUCTION CAREFULLY BEFORE OPERATING THE UNIT 10. USB DRIVE OPERATIONS COMPATIBILITY P . 1 Due to the fast changing technology world, this unit may or may not be compatible to all the USB drive / device available with all the future technology, especially those USB drive / device which require to install a driver. Always choose a compatible USB drive / device which is compatible with this unit. NOTE: This unit is not compatible with portable Hard-Disk. START THE USB DEVICE MODE 1. The USB socket is covered by the USB plastic cover as indicated in picture 1 (P . 1). Flip open the USB plastic cover, and the USB socket will become accessible. Please connect the USB drive /device to the unit thru the USB cable as indicated in picture (P . 2), and the display will show "USB PLAY". . . . . . . . . the download has begun. P . 2 NOTE: 1 Mini USB to big USB extension cable 2 The unit may take a while to detect or download the USB files, detect & download time may vary depends on the type of USB drive / device. [. . . ] Please skip this description if your model is not equipped with this feature. THERE ARE FOUR WAYS TO SELECT YOUR FAVORITE TRACK / DIRECTORY A) SEARCHING TRACK DIRECTLY Under MP3 play mode, press MP3 MENU BUTTON once, the display shows "MP3 T*", enter the desired track number directly, then press MP3 ENTER BUTTON to confirm. The distribution of the number are listed as follow: Number 1 M1 2 M2 3 M3 4 M4 5 M5 6 M6 7 MODE 8 TUNE. DN 9 TUNE. UP 0 DISP Button SEARCH TRACK NUMBER BY USING ENCODER VOLUME KNOB Rotate the ENCODER VOLUME KNOB to scroll through the numbers, then press MP3 ENTER BUTTON to confirm. B) SEACRCHING BY DIRECTORY OR TRACK NAME (1) SEARCH DIRECTORY / TRACK NAME BY USING TUNE UP / DOWN BUTTON Under MP3 Play Mode, press MP3 MENU BUTTON twice, the display shows " * " , enter the character directly. The unit searches files and directories which have the same character which is inputted by the user. The unit shows these sorted files and directories by TUNE UP / DOWN Button (TUNE DOWN First). [. . . ]