User manual VIEWSONIC PJD5555LW

[. . . ] PJD5151/PJD5153/PJD5155/ PJD5250/PJD5253/PJD5255/ PJD5555w_Tiger DLP Projector User Guide IMPORTANT: Please read this User Guide to obtain important information on installing and using your product in a safe manner, as well as registering your product for future service. Warranty information contained in this User Guide will describe your limited coverage from ViewSonic Corporation, which is also found on our web site at http:// www. Com in English, or in specific languages using the Regional selection box in the upper right corner of our website. “Antes de operar su equipo lea cu idadosamente las instrucciones en este manual” Model No. [. . . ] To correct this situation, see "Correcting keystone" on page 26 for details. Auto-adjusting the image In some cases, you may need to optimize the picture quality. Within 3 seconds, the built-in Intelligent Auto Adjustment function will re-adjust the values of Frequency and Clock to provide the best picture quality. The current source information will be displayed in the upper left corner of the screen for 5 seconds. This function is only available when PC D-Sub input signal (analog RGB) is selected. Correcting keystone Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. To correct this, besides adjusting the height of the projector, you will need to manually correct it following one of these steps. € Using the remote control Press / to display the Keystone correction page. Press to correct keystoning at the top of the image or press to correct keystoning at the bottom of the image. / Magnifying and searching for details If you need to find the details on the projected picture, magnify the picture. Using the remote control Press on the remote control to display the Zoom bar. To navigate the picture, press Enter to switch to the paning mode and press the directional arrows ( , , , ) to navigate the picture. To reduce size of the picture, press Enter to switch back to the zoom in/out functionality, and press repeatedly until it is restored to the original size. You can also press Auto Sync on the remote control to restore the picture to its original size. To change the projected image ratio (no matter what aspect the source is): 1. Press / to select an aspect ratio to suit the format of the video signal and your display requirements. About the aspect ratio In the pictures below, the black portions are inactive areas and the white portions are active areas. Auto: Scales an image proportionally to fit the projector's native resolution in its horizontal width. This is suitable for the incoming image which is neither in 4:3 nor 16:9 and you want to make most use of the screen without altering the image's aspect ratio. 4:3: Scales an image so that it is displayed in the center of the screen with a 4:3 aspect ratio. This is most suitable for 4:3 images like computer monitors, standard definition TV and 4:3 aspect DVD movies, as it displays them without aspect alteration. 16:9: Scales an image so that it is displayed in the center of the screen with a 16:9 aspect ratio. [. . . ] Some states do not allow limitations on implied warranties and/or do not allow the exclusion of incidental or consequential damages, so the above limitations and exclusions may not apply to you. And Canada: For warranty information and service on ViewSonic products sold outside of the U. The warranty period for this product in mainland China (Hong Kong, Macao and Taiwan Excluded) is subject to the terms and conditions of the Maintenance Guarantee Card. For users in Europe and Russia, full details of warranty provided can be found in www. [. . . ]