User manual VINCENT PHO-111

[. . . ] There are no parts in the appliance that require maintenance by the user. All equipment that is connected to the domestic mains voltage can be dangerous to the user if not handled properly. Altering the product or manipulating its serial number voids the warranty. the device is only permitted for the connection to AC 230 V / 50 Hz , for grounded mains sockets and for indoor use. [. . . ] It can be changed at any time without prior notice and does not constitute any obligation on the part of the trademark's owner. The latter assumes no responsibility or liability for errors or inaccuracies, which may be included in these operating instructions. It is a product of Sintron Vertriebs GmbH, 76473 Iffezheim and may not be copied or distributed partly or in full without express, written consent. Please check the contents of the packaging, which in addition to the appliance should contain the following accessories: · POWER LED This LED is lit as long as the PHO-111 is connected to its power supply that is connected to the mains and ready for use. GND: Ground clamp for the record player In addition to the stereo signal connection cable most record players are equipped with a grounding cable that can be recognized by the cable lug at the end of the cable. IN: signal input from the record player The audio output (or as well an attached audio cable) of the record player must be connected to these input sockets. MC/MM I/MM II: pickup type switch At this switch the type of record player pickup system has to be selected to adapt the phono preamplifier PHO-111 to that system. OUT: signal output to the amplifier A pair of RCA input sockets of your system's audio amplifier must be connected with these output sockets. 12-16V AC: power supply input of the PHO-111 Plug in the power connector at the end of the cable (8) of the supplied AC adaptor (7). Always connect the AC adaptor to the mains before you switch on the amplifier/preamplifier!AC ADAPTOR: power supply with power plug This power supply adaptor is supplied with the PHO-111 and converts the mains voltage to a more suitable supply voltage. After you made the connection to the PHO-111, plug it into a mains socket as the last step of the Installation. Power Supply Cable Make a connection to the PHO111 back plate power socket (6). Never make changes to the cable connections while the devices are switched on! mechanically identical RCA plugs are available for input and output connections. Make sure that you do not get these connections confused during installation!Also make sure that you do not mix up the analogue inputs for right and left. The RCA plugs for these are frequently colour coded as follows: red for the right channel, black or white for the left channel. Inadequate connections can cause noise interference, failures and malfunctions. Make sure that the weight of the cabling does not cause the PHO-111 to lose contact to its base. That is why you should place both appliances at maximum distance to potential sources of disturbance like mains cables, mobile phones, switching power supplies, transformers, computers and main amplifiers. To make the most of your system's sound quality, we recommend placing the equipment on Vincent racks and not putting them on top of each other. [. . . ] Your local HiFi specialist will assist you if there is any help needed. Plug in the power supply cable (8) to the PHO-111 power socket "12­16 V" (6). Check whether the wall mains socket provides the appropriate mains power, which is the case if it is supplied with 230 V AC 50 Hz. After all other cable connections have been made push the power supply into a mains socket. [. . . ]