User manual VISONIC KF-234 PG2

[. . . ] INTRODUCTION KF-234 PG2 is a miniature PowerG 4-button (6-function) keyfob, designed for use with the PowerMaster-10. Transmission is initiated by pressing any one of the four recessed pushbuttons. Upon pressing a specific button, the KF-234 PG2 transmits a PowerG message associated with the button that was pressed and identifiable by PowerMaster-10 control panels. [. . . ] To Modify the Keyfob Device Settings Refer to the PowerMaster-10 Installer Guide and perform the procedure for Adding A Wireless Device (section 4. 5. 2), or, Modifying a Device (section 4. 5. 5). AUX A When exiting "ZONES / DEVICES" menu the PowerMaster-10 system displays the number of devices that need to be updated, as follows: DEV UPDATING NNN. For detailed instructions on Adding Devices, Deleting Devices, Replacing Devices and Defining Defaults see the PowerMaster-10 Installer Guide. or Select between "instant", "skip exit delay" and "PGM". Here you select the function of the AUX button on the KF-234 PG2 keyfob. 5. OPERATION Initiate Panic Alarm: Press ARM AWAY and ARM HOME together for 2 seconds. Status: Press ' ' button once. D-302416 1 C A B D E A. MAINTENANCE 6. 1 Replacing the Battery A replacement 3V battery, CR-2032, is available from hardware and electrical supply stores. Dispose of used batteries according to the manufacturer's instructions. Using the screwdriver, push out the battery from its holder and install new battery (polarity "+" as shown). Test the unit by momentarily pressing one of the Transmit buttons ­ the LED should light. Battery Figure 3: Battery Replacement 1 6. 2 Cleaning A The keyfob may get dirty if touched with greasy fingers. Clean it only with a soft cloth or sponge moistened lightly with a mixture of water and mild detergent, and wipe it dry immediately. C D The use of abrasives of any kind is strictly forbidden. Also never use solvents such as kerosene, acetone or thinner. 2 B 3 7. TESTING A NEW UNIT Since the KF-234 PG2 is supplied with the battery already installed, the unit is practically ready to be tested. Stand 3 m (10 ft) away from a target control panel (or wireless control panel) and press the ARM AWAY button (see Fig. [. . . ] (UK): UNIT 6 MADINGLEY COURT CHIPPENHAM DRIVE KINGSTON MILTON KEYNES MK10 0BZ. TEL: (0870) 7300800 FAX: (0870) 7300801 PRODUCT SUPPORT: (0870) 7300830 VISONIC GmbH (D-A-CH): KIRCHFELDSTR. 118, D-40215 DÜSSELDORF, TEL. : +49 (0)211 600696-0, FAX: +49 (0)211 600696-19 VISONIC IBERICA: ISLA DE PALMA, 32 NAVE 7, POLÍGONO INDUSTRIAL NORTE, 28700 SAN SEBASTIÁN DE LOS REYES, (MADRID), ESPAÑA. [. . . ]