User manual VIVITAR VIVICAM 3750

[. . . ] V3750 User Manual English 041020TP FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Press the shutter button. Note: The flash mode is disabled in the portrait focus setting. EN-19 Normal Focus The normal focus setting, suitable for scenery shooting, is used when the distance to the subject is greater than 5 feet. Set the focus dial located on the front side of the camera to the position. Press the shutter button. Digital Zoom Using digital zoom, images appear closer. Whereas digital zoom is a compelling feature, the more an image is enlarged (zoomed), the more pixilated (grainier) the image will appear. Press the shutter button to capture a "zoomed" image. Note: The more the image is enlarged, the more pixilated (grainier) the image. The self-timer LED blinks slowly for seven seconds and then blinks rapidly for the last three seconds. To cancel the self-timer at any time, press the shutter button to disrupt the sequence. Note: After an image is taken using self-timer, the self-timer mode is turned off. If you wish to take another image using the self-timer, repeat these steps. EN-21 Flash The flash is designed to function automatically when lighting conditions warrant the use of flash. You can capture an image using a flash mode suitable to your circumstances. If you change the flash mode, the camera will retain that setting even if the camera is turned off. Turning the flash OFF will result in faster camera startup and faster operation because the capacitor will not be charged needlessly. Turning the flash OFF when not needed, will also improve battery life. Flash mode is disabled during portrait focus setting to avoid over-exposed photos. EN-22 The ViviCam 3750 has three flash modes: Automatic Flash (default), Automatic with Red-eye reduction and Flash Off. The table below will help you choose the appropriate flash mode: Flash mode Automatic flash Description The flash fires automatically according to the ambient lighting conditions. Select this mode for general flash photography. The flash emits a precursor-flash before the main flash fires. Automatic with This Red-eye reduction causes the pupil in the human eye to Red-eye reduction constrict, reducing the red-eye phenomenon. Select this mode when capturing images of people and animals in low-light conditions. Select this mode when capturing images in a place where flash photography is prohibited, or when the distance to the subject is beyond the effective range of the flash. Note: The Flash mode is disabled when the portrait focus setting is used. EN-23 PLAYBACK MODE In the mode, you can view, magnify, delete images, play video clips, or run a slide show. Playback mode also provides a thumbnail image display, allowing you to quickly search for the image you want. Viewing Images 1. To view the previous image, press the To view the next image, press the button to Press the button (same as the / button) once to display the detailed image information such as image quality & size, time and date. Note: If there are no images stored in memory, the "NO IMAGES" message will appear on the LCD monitor. First connect one end of the video cable to the VIDEO OUT jack of the ViviCam 3750. [. . . ] And for more information about Setup Menu, refer to the Setup menu section. EN-44 Playback Menu Use the playback menu to create an on-camera slide show or transfer images from internal memory to a memory card. To access the playback menu, press the button in the mode and navigate through the options by using the / button. SETUP MENU Press the OK button to access the Setup Menu. For more information about Setup Menu, refer to the Setup menu section. SLIDE SHOW Refer to section in this manual titled "Slideshow Display" in the PLAYBACK MODE for further details. ERASE Refer to section in this manual titled "Deleting Images" in the PLAYBACK MODE for further details. COPY TO CARD This feature allows you to copy your images from the camera's internal memory to a memory card. Of course, you can only do this if you have a memory card installed and some images in internal memory. [. . . ]