User manual WACOM CINTIQ 21UX DTK-2100

[. . . ] No part of this manual may be reproduced except for your express personal use. Wacom reserves the right to revise this publication without obligation to provide notification of such changes. Wacom does its best to provide current and accurate information in this manual. However, Wacom reserves the right to change any specifications and product configurations at its discretion, without prior notice and without obligation to include such changes in this manual. [. . . ] The Cintiq status LED should light blue each time you click with the tool tip, press the side switch, or press the tool eraser to the display screen. (PRESSURE should change from approximately 0% with no pressure applied to approximately 100% when full pressure is applied. ) · Next, press the side switch without pressing the tip to the tablet. (PRESSURE should change from approximately 0% with no pressure applied to approximately 100% when full pressure is applied. The WHEEL value should decrease to a value of approximately 0 when the fingerwheel is all the way forward. The WHEEL value should increase to approximately 1000 when the fingerwheel is all the way back. Test tilt for the x-axis by moving the pen from a vertical position toward the right; the X TILT value should change from approximately 0 to +60. Now move the tool to the left of vertical; the X TILT value should change from approximately 0 to - 60. Test the tilt for the y-axis by moving the pen from a vertical position toward the bottom of the tablet; the Y TILT value should change from approximately 0 to +60. Now move the tool toward the top of the tablet; the Y TILT value should change from approximately 0 to - 60. If you encounter problems with the display portion of your Cintiq, refer to the following tables; your problem may be described here and you can try the solution offered. For additional information about color issues, see the documentation that came with your operating system or applications. Verify that the light on the AC power adapter is on and the power cable is securely plugged into Cintiq's power receptacle. Touch the pen tip to the Cintiq display screen, move the mouse, or depress any key on your keyboard. Then properly connect the video cable and turn on the pen display and your computer. Check the video cable and any video adapters for bent or broken connector pins. Then properly reconnect the cables and turn on Cintiq and your computer. A `no signal go to power save' message appears briefly on your display screen. A `cable disconnect go to power save' message briefly appears on your display screen. When a still image is displayed for a long period of time without refreshing the screen, an afterimage remains for a short period of time. The input signal frequency is incorrectly set or not compatible with Cintiq. set the refresh rate to a vertical frequency that is compatible with Cintiq. [. . . ] You can determine whether the equipment is causing interference by powering it off. If the equipment does cause interference to radio or television reception, you may be able to correct the interference by using one or more of the following measures: · Rotate the television or radio antenna until the interference stops. Plug the equipment and computer into an outlet that is on a different circuit from the television or radio. If necessary, consult your Wacom dealer or an experienced radio/television technician for help. [. . . ]