User manual WHIRLPOOL ACM 707 BA

[. . . ] Disposal of packaging materials: dispose of the various packing materials responsibly, in full compliance with local authority regulations governing waste disposal. This induction hob is designed solely for use as a domestic appliance. The appliance is not intended for use by persons (children included) with physical, sensory or mental impairment or without experience and knowledge of the appliance, unless supervised or previously instructed in its use by those responsible for their safety. The cooking zones become extremely hot during use: be careful and keep children away from the appliance to avoid the risk of scalding or burns. [. . . ] Each time the cooktop is connected to the mains it carries out an automatic check which lasts several seconds. 400V 3N ~ 230V ~ 230-240V~FOR AU ONLY 230V~FOR UK ONLY 230V 230V 230V 230V 400V 2N ~ 230V 3~ ONLY FOR BELGIUM 400V 2N~ FOR NL ONLY 230V 230V A 230V 230V B C 61 230V 230V 230V Installation and fixing The installer is responsible for any damage or injury resulting from incorrect installation. To guarantee correct operation, the appliance must be installed on a perfectly flat surface. For cut-out dimensions, see the figure below. Dimensions in mm 580 510 +1 0 The worktop must be 20-50 mm thick. If necessary, cut the kitchen unit and worktop to fit before installing the hob. Clean the cutout of any chips that could compromise appliance operation. 770 510 +1 0 483 553 min. 8 +2 0 490 560 490 750 For flush mounted installation or setting into a marble worktop, contact the After-sales Service for the installation kit and necessary instructions. To guarantee correct operation, the appliance must be installed on a perfectly flat surface. If necessary, cut the kitchen unit and worktop to fit before installing the hob. Clean the cutout of any remaining dust that could compromise appliance operation. For the distance between the underside of the induction hob and the kitchen unit (or separating panel), observe the dimensions given in the figure at the side. If a column unit is installed adjacent to the hob, leave a distance of at least 100 mm from the edge of the hob. min. Fit the brackets (C) in the centre of the vertical sides, aligning the upper edge of the brackets so that they are flush with the worktop surface (fig. Fix the brackets with the 4 screws supplied (B) using the holes provided. Insert the hob in the cutout, making sure the clips (A) are secured in the spaces provided (fig. 4 Undercounter oven installation: · If an oven (which must be of our manufacture) is to be installed under the hob, ensure it is equipped with a cooling system and observe the distances given in the figure to the side. · There must be nothing between the cooktop and the oven (cross rails, panels, brackets, etc. ). 5 mm OPERATING INSTRUCTIONS Control panel Timer On/Off Child safety the symbols are not active!To select the desired functions, touch the areas below. Cooking zone controls and corresponding display Switching the hob ON/OFF To switch the hob on, press the button for approx. All the cooking zones are switched off. If the hob has been in use, the residual heat indicator "H" remains lit until the cooking zones have cooled down. The hob automatically switches off if no function is selected within 10 seconds of switching on. 63 Switching on and adjusting cooking zones Heat setting indicator Button Cooking zone positioning Button + Selected cooking zone indicator After switching on the hob and positioning the pot on the chosen cooking zone, adjust the heat setting using the button +. Each cooking zone has different heat settings that can be adjusted using the buttons +/-, which go from "1": min. [. . . ] If any repairs are required, please contact an authorized After-sales Service as indicated in the warranty. 65 Failure to comply with these instructions may compromise the safety and quality of the product. Appliance data plate MODEL SERIALNUMBER BRAND USER ADVICE Energy saving tips For optimum results, observe the following advice: · Use pots and pans whose bottom diameter is equal to that of the cooking zone. · Make sure you place the pot or pan in the centre of the cooking zone outlined on the hob. · The symbol on the appliance, or on documentation enclosed with the appliance, indicates that this product must not be treated as household waste, but must be delivered to the nearest collection centre for the recycling of electrical and electronic appliances. Disposal must be carried out in accordance with local environmental regulations for waste disposal. [. . . ]