User manual WHIRLPOOL AWE 6523 INSTRUCTION FOR USE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL AWE 6523. We hope that this WHIRLPOOL AWE 6523 user guide will be useful to you.


WHIRLPOOL AWE 6523 INSTRUCTION FOR USE: Download the complete user guide (679 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL AWE 6523 PROGRAMKORT (191 ko)
   WHIRLPOOL AWE 6523 PROGRAMKORT (191 ko)
   WHIRLPOOL AWE 6523 MODE D'EMPLOI (1193 ko)
   WHIRLPOOL AWE 6523 BRUGSVEJLEDNING (644 ko)
   WHIRLPOOL AWE 6523 BRUGSVEJLEDNING (644 ko)
   WHIRLPOOL AWE 6523 TABLEAU DE PROGRAMMES (211 ko)
   WHIRLPOOL AWE 6523 PROGRAM CHART (189 ko)

Manual abstract: user guide WHIRLPOOL AWE 6523INSTRUCTION FOR USE

Detailed instructions for use are in the User's Guide.

[. . . ] 3GB10248. fm Page 1 Monday, May 24, 2004 5:33 PM CONTENTS BEFORE USING THE WASHING MACHINE FIRST WASH CYCLE PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE WASHING MACHINE PREPARATION OF THE WASHING DETERGENTS AND ADDITIVES PROGRAMME SELECTION CLEANING THE FOREIGN BODY TRAP DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE TRANSPORT AND HANDLING INSTALLATION ELECTRICAL CONNECTION Black process 45. 0° 100. 0 LPI 3GB10248. fm Page 2 Monday, May 24, 2004 5:33 PM BEFORE USING THE WASHING MACHINE 1. Remove the packaging and check a. Remove the bottom protection by tilting and turning the washing machine on one rear bottom corner. • After unpacking, make sure that the washing machine is undamaged. • Keep the packaging materials (plastic bags, polystyrene parts, etc. ) out of reach of children; they are potentially dangerous. 6. Electrical connection • Electrical connections must be carried out by a qualified technician in compliance with the manufacturer’s instructions and the current standard safety regulations. [. . . ] Make sure the pump impeller (in the housing behind the foreign body trap) is not obstructed. Insert the foreign body trap again and screw it fully down in a clockwise direction to the stop (until the grip is horizontal). Pour 0. 5 litres of water into the machine via the drum and check that water does not leak from the foreign body trap. Check the foreign body trap if the washing machine is not draining correctly or if it fails to perform spin cycles. The machine has safety device which stops the washing machine before each filling when water was not removed completely from the tub in previous part of washing programme. Check the foreign body trap regularly, two or three times a year and clean it if necessary. IMPORTANT: Make sure the water has cooled before emptying the foreign body trap. GB 9 Black process 45. 0° 100. 0 LPI 3GB10248. fm Page 10 Monday, May 24, 2004 5:33 PM DRAINING RESIDUAL WATER When should I drain residual water (draining problem)?• If the washing machine is installed in a room subject to subzero temperatures. • If the draining problem indicators are flashing (see “Troubleshooting Guide”) 1. Turn off the tap, disconnect the water supply hose from the machine and allow the water to drain into a basin. Open the foreign body trap, let the water drain into a small shallow basin and close the trap. Release the drain hose then open the fixing clip located at the rear of the machine (see arrow A). Fix the drain hose again with the clip and replace it with the U-bend. Important: • After draining the residual water, screw on the machine’s water supply hose by hand. Check water-tightness of washing machine connections by turning the tap completely on. A CARE AND MAINTENANCE Detergent dispenser 1. Replace the dispenser by locating the bottom tabs in the lid holes and pivot until both of the upper buttons lock. Note: ensure that the detergent dispenser is correctly reinstalled. GB 10 Black process 45. 0° 100. 0 LPI 3GB10248. fm Page 11 Monday, May 24, 2004 5:33 PM Water inlet hose filter Check and clean regularly (at least two or three times a year). Carefully clean the filter located at the end of hose, without assembling it, for example with a tooth-brush. Note: For machines equipped with hose type “A”, it must not be submerged in water. Plug the washing machine back in. A Recovering an object that falls between the drum and the tub If an object accidentally falls between the drum and the tub, you can recover it thanks to one of the removable drum blades: 1. Using a screw-driver, press on the plastic end while sliding the blade from left to right. Open the drum: you can recover the object through the hole in the drum. [. . . ] • The washing machine must not be connected to the mixing tap of a non-pressurized water heater!• The inlet hose and the plastic enclosure contain (depending on model) electrical components: do not cut the hose and do not immerse the enclosure in water. • If the flexible hose is damaged, unplug the washing machine from the mains immediately, turn off the tap and replace the hose. If the flexible hose is too short, replace it with a 3 m Water Stop hose (available from After-Sales Service or from your dealer). [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL AWE 6523




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL AWE 6523 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.