User manual WHIRLPOOL WAB 1000 SW INSTRUCTION FOR USE

[. . . ] • Mains cable replacement is only to be carried out by After-Sales Service. • The washing machine must only be used in the household for the prescribed uses. 4. Water inlet • Connect the water supply inlet hose in accordance with the regulations of your local water company (see "Installation/Connect the water supply hose"). • Water supply: Cold water only 3/4” threaded • Tap: hose connection • Pressure: 100-1000 kPa (1-10 bar). 2. Remove the transit bolts • The appliance is fitted with transit bolts to prevent internal damage during transport. Before using the washing machine you must remove the transit bolts (see “Installation/ Remove the transit bolts”). 5. Drain hose • Connect the drain hose to the ventilated siphon or hook it over the edge of a sink by means of the "U" bend (see "Installation/ Connect the water drain hose"). 4gb15150. fm Page 3 Monday, July 8, 2002 7:00 PM First wash cycle We recommend that the first wash cycle be made without laundry. [. . . ] Only use this chamber if the “Bleach” column is shown on the enclosed programme chart. Slide the detergent dispenser in until it clicks shut. liquid detergentuse front slot Divider insert and in the rear slot when using powder detergent (See marking). powder detergentuse rear slot Divider insert 4gb15150. fm Page 7 Monday, July 8, 2002 7:00 PM Notes: • Keep detergents and additives in a dry place and out of reach of children. • If you use descaling agents, dyes or bleaches, make sure they are suitable for washing machine use. Descaler could contain components that can attack parts of your washing machine. • Do not use solvents (turpentine, benzine, etc. ) Do not machine wash fabrics that have been treated with solvents or flammable liquids. • You can use liquid detergent in the "Prewash" phase for programmes with this option. In this case put only powder detergents in the compartment for the main wash . • When using concentrated fabric softeners, dilute with water in the detergent dispenser up to "MAX" level mark. • To prevent dispensing problems when using highly concentrated powder and liquid detergents, use the special detergent ball or bag supplied with the detergent and place it directly inside the drum. If you use gel-type detergent, please use the powder detergent insert setting. Powder detergent remains in the detergent dispenser until the programme starts, but liquid detergents can run out of the detergent dispenser. • If you use powder starch, proceed as follows: 1. Wash your laundry using the desired wash programme. 3. Set the “Rinse and Spin” programme, reduce the speed to ca. 4. Pull the detergent dispenser out until you can see about 3 cm of the 5. While the water is running into the detergent dispenser, pour the starch solution into the chamber. 6. If there are starch residues in the detergent dispenser after the end of the programme, clean it if necessary (see "Care and Maintenance"). Observe also the starch manufacturer's information. Care and Maintenance Appliance exterior and control panel • Clean using normal household cleaner (do not use abrasive products or solvents). • Dry with a soft cloth. Door seal • Clean occasionally with a damp cloth. • Check the seal folds for foreign bodies periodically. • 4gb15150. fm Page 8 Monday, July 8, 2002 7:00 PM Detergent dispenser 1. Press the release lever in the prewash compartment down and pull out the dispenser. 4. Replace the separate parts in the detergent dispenser and slide the dispenser back into the opening. Periodically check and clean the mesh filters in the water connection. 1. 8. Turn on the tap and ensure that the connections are watertight. Troubleshooting Guide This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately. Often, however, the faults detected are small enough to be solved in a matter of minutes. [. . . ] Note: The inlet hose and the plastic enclosure at the water connection contain electrical components. For this reason, do not cut the hose and do not immerse the plastic enclosure in water. B Connect the water drain hose 1. Connect the drain hose to the ventilated siphon or hook it over the edge of a sink with the “U” bend. Secure the hose so that it cannot fall down while the appliance is running. [. . . ]