User manual WYSS MENAGE6200

[. . . ] Washing machine MENAGE 6200 Instructions for use Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. The following symbols are used in the text: 1 Safety instructions 3 Useful tips and hints 2 Environmental information Warning: Notes that concern your personal safety. Attention: Notes that show how to avoid damage to the appliance. 2 Contents Instructions for use . 4 4 5 5 6 8 9 9 9 9 10 11 11 12 12 12 12 12 13 13 13 13 13 14 15 16 16 18 19 20 21 22 22 23 23 23 23 24 25 26 26 26 27 28 31 Installation and connection instructions. [. . . ] Adjust the feet as described in the installation and connection instructions. Mix large and small items. 16 Problem Possible cause Screw connection on the inlet hose is leaking. Follow the manufacturer's instructions exactly when measuring out detergent. Turn off the tap, remove the mains plug from the power point and inform the Customer Care Department. Drain pump cover is not closed Water is running out from under properly. Possibly too much detergent was used. The drain pump runs constantThe Aqua Control anti-flood system ly, even when the machine is has responded. FLUFF FILTER indicator is flashing. The water cannot be drained comSwitch off the appliance and disconpletely because the drain hose is nect the mains plug. Check the water kinked or clogged or the water outlet outlet and clean, if necessary. Maximum pumping height of 1m ex- Please refer to the water outlet inceeded. structions at the back of this book. E20 appears in the multi-display. (Problems with water outflow) Drain pump is blocked. Switch off the appliance. Clean the sink spigot. For sink spigot connections: The sink spigot is blocked. Conditioner not rinsed in, w compartment for additives is filled with water. Conditioner insert in the compartClean the detergent drawer, insert the ment for additives is not correctly atconditioner insert firmly. The programme will continue when the power cut is over. The door cannot be opened when the washing machine is switched on. There has been a power cut. (All indiTo remove washing: cators are off. ) The door remains locked for approx. If water can be seen in the appliance, before opening the door, first drain off 4 to 10 minutes. (See section "Carrying out an emergency drain". ) Possibly too much washing was loaded. Observe maximum loads. Washing is heavily creased. 17 If the wash results are not satisfactory Washing is grey and scale is being deposited in the drum · · · · Too little detergent is being used. Programme or temperature was not correctly set. There are grey stains on the washing. · Washing soiled with ointment, grease or oil was washed with too little detergent. · A common cause is that fabric conditioner ­ especially a concentrate ­ has got onto the washing. Such stains should be washed out as quickly as possible and make sure that you are careful when using fabric conditioner. After the last rinse foam can still be seen. · Modern detergents may create foam even in the last rinse cycle. The washing is however sufficiently rinsed. There are white residues on the washing. · This is due to the insoluble ingredients in modern detergents. Especially with dark colours it is advisable to use liquid detergents. 18 Carrying out an emergency drain off the washing machine and remove the mains plug from the socket. [. . . ] To tighten or loosen the threaded hose fitting, never turn the housing of the safety valve, as otherwise the inner hose will be damaged. Open the water tap slowly and check all connections for water tightness. 27 Water drainage The maximum permitted difference between the height of the surface on which the appliance is installed and the water outlet is 1 metre. The Customer Care Department carries outlet hoses of varying lengths. Draining water through a spigot Secure the spout/spigot connection with a hose clamp (obtainable from specialist shops). Draining water into a basin/bathtub Important: ­ Small basins are not suitable. ­ The end of the drain hose must not dip into the water which has been pumped out. [. . . ]