User manual X10 IN12A SETUP
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual X10 IN12A. We hope that this X10 IN12A user guide will be useful to you.
Manual abstract: user guide X10 IN12ASETUP
Detailed instructions for use are in the User's Guide.
[. . . ] Setting Up the X10 Firecracker Kit
the female DB9 connector on the Interface directly to your PC's serial port. [. . . ] If there are any difficulties when attempting to send control commands to the Transceiver, try all of the available COM ports on the computer. If the problems persist, ensure that the Transceiver is operating correctly by following steps 2 and 3 above. For more help, see: http://www. x10. com/support Notes:
Set Up the Transceiver Module Make sure you have connected the Transceiver (model TM751) to a nearby power outlet. The outlet you use should not be too close to the back of your PC, as your PC may create some electrical noise that could reduce the range of the transceiver. Set the House Code (letter dial) on the Transceiver is set to 'A'. Plug a lamp directly into an outlet, and ensure that it is switched on. Next, without switching the lamp off, remove it from the outlet and connect it directly to the Transceiver. Using the PalmPad wireless remote (model HR12A), press the '1 On' button. [. . . ] If you haven't already done so, connect
MODEL NUMBER: IN12A
Copyright 1999 X10 (USA) Inc. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE X10 IN12A
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual X10 IN12A will begin.