User manual X10 KR19A

[. . . ] KR19A SlimFireTM Remote installation and operating instructions The KR19A works with the RR501 (part of the RC5000) and the TM751 (part of the RC6500). It lets you turn on and off two individually coded X-10 Modules and brighten and dim lights connected to Lamp Modules and Wall Switch Modules. [. . . ] 3 seconds later, the LED blinks the current setting: 1 blink for Housecode A, 2 blinks for B. . . . . · Press and release the first (top) ON button the appropriate number of times for the Housecode you want to set. If you do not follow this programming sequence, the LED will stay on for 1 second and your existing setting will not be changed. To change the Unit Code for the first (top) two buttons (the second pair of buttons are always one # higher than the first pair, i. e. if you set the first button to 6, the second button controls 7, etc. ). 3 seconds later, the LED blinks the current setting: 1 blink for Unit Code 1, 2 blinks for 2, 16 blinks for 16. · Press and release the top OFF button the appropriate number of times for the Unit Code you want. If you do not follow this programming sequence, the LED will stay on for 1 second and your existing setting will not be changed. To change the battery: Pry the unit apart and fit a CR2025 Lithium 3V battery. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. ANY CHANGES MADE TO THE UNITS WILL VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. Press to turn A1 ON. After pressing a number, press and hold to Brighten. Press to turn A1 OFF. [. . . ] Please visit www. x10. com/warranty to complete your on-line warranty registration. For help or more information on setup, please visit: www. x10. com/support KR19A-9/01 [. . . ]