User manual X10 MS12A

[. . . ] Set-Up and Operating Instructions for MS12A Motion Sensor The MS12A Motion Detector sends Wireless Radio Frequency (RF) signals to an X10 Transceiver (RR501 or TM751) or any X10 security system base receiver. The receiver then passes the signals onto your house wiring to turn on lights (or appliances) around your home. [. . . ] Place the MS12A in a dark drawer for several minutes before testing it. Plug in an X10 RF Transceiver (model RR501 or TM751, sold separately) or any X10 security system base receiver (sold separately) and set it to Housecode A. Plug a lamp into an X10 Lamp Module (sold separately) and set it to Housecode A and Unit Code 1. To test the MS12A: After the MS12A has stabilized in a dark place for a few minutes take it out of the dark and move it. (Note: the red lights blinks the appropriate number of times for the code that is set, once for A1, 4 times for A4, etc. ). Place the MS12A on a shelf or mount it on a wall at least 6 feet above the ground. You can also turn the light off from any X10 controller or set up a CM11A Computer Interface (sold separately) to initiate a macro when it receives A1. B2, C7, and H9) when you walk into a room and turn them off after a preset time. To change the Unit Code for the MS12A: Press and hold the Unit button (under the battery compartment lid) until the red light blinks twice, then release and press the button the desired number of times for the Unit Code you want (once for Unit Code 1, twice for Unit Code 2, etc. ). The light blinks each time you press, and confirms your entry by blinking the number of times you pressed the button about 2 seconds after your last press. Use the same procedure to change the Housecode (pressing the House button instead). To check what code you've set: press and release the House or Unit code button - the light blinks back the appropriate number of times for the code that is set. [. . . ] Please visit www. x10. com/warranty to complete your on-line warranty registration. of X10 Wireless Technology, Inc. , 3824 North 5th St. , Suite C, North Las Vegas, NV 89032. [. . . ]